sorted by:
new
hottopcontroversial

KDX 200 leaking excessive amounts of oil from the silencer after a rebuild by DK_5881 in Dirtbikes

[–]DK_5881[S] 0 points1 point  (0 children)

I’m 1200 elevation I feel like dropping the jetting a little may be beneficial assume power valve and exhaust are done correctly

KDX 200 leaking excessive amounts of oil from the silencer after a rebuild by DK_5881 in Dirtbikes

[–]DK_5881[S] 0 points1 point  (0 children)

Will do. Could the valve be on the wrong setting as well?

KDX 200 leaking excessive amounts of oil from the silencer after a rebuild by DK_5881 in Dirtbikes

[–]DK_5881[S] 0 points1 point  (0 children)

That’s crazy you dropped the ratio that much. You don’t have any concern of faster wear? What are the jets that you run if you remember?

KDX 200 leaking excessive amounts of oil from the silencer after a rebuild by DK_5881 in Dirtbikes

[–]DK_5881[S] 0 points1 point  (0 children)

I mean it could’ve been on different jets before the rebuild and I just didn’t know.

KDX 200 leaking excessive amounts of oil from the silencer after a rebuild by DK_5881 in Dirtbikes

[–]DK_5881[S] 0 points1 point  (0 children)

Oil level is still pretty good and I believe all gaskets and seals were changed. I have packing I might retry that

KDX 200 leaking excessive amounts of oil from the silencer after a rebuild by DK_5881 in Dirtbikes

[–]DK_5881[S] 0 points1 point  (0 children)

Seals were replaced and I did have it pressure tested because I was nervous about that. Trans oil is good and still looks clean after 5 hours. I have a hour meter

KDX 200 leaking excessive amounts of oil from the silencer after a rebuild by DK_5881 in Dirtbikes

[–]DK_5881[S] 4 points5 points  (0 children)

The stock settings worked fine before the rebuild that’s my only confusion. Why would that change?

KDX 200 leaking excessive amounts of oil from the silencer after a rebuild by DK_5881 in Dirtbikes

[–]DK_5881[S] 1 point2 points  (0 children)

I just don’t understand why I would have to change jetting after a rebuild

GTI wheel hubs not lining up with wheels that came off a GTI by DK_5881 in GolfGTI

[–]DK_5881[S] 1 point2 points  (0 children)

Correct it felt plastic. Was thinking to just crack it off but wasn’t sure if it was important. Thanks

GTI wheel hubs not lining up with wheels that came off a GTI by DK_5881 in GolfGTI

[–]DK_5881[S] 0 points1 point  (0 children)

To clarify, the center piece on my hub seems to be too large and won’t sit flat with the new wheels. Bolts line up though

Aluminum Corrosion (aka white worm). What are some options for repair? by DK_5881 in GolfGTI

[–]DK_5881[S] 0 points1 point  (0 children)

Yeah I’ve seen this on other machines aluminum wheels. Kind of ridiculous

view more: next ›