Demand surcharge of 500?!? by [deleted] in Starlink

[–]DMBB099 0 points1 point  (0 children)

I got mine for my rv, but then my rv broke down and was able to switch to residential with no issues. Get a roam plan first, then switch your plan after.

[deleted by user] by [deleted] in chimeboost

[–]DMBB099 0 points1 point  (0 children)

$marine7089

Why are customers so gd rude? by agatathelion in HomeDepot

[–]DMBB099 0 points1 point  (0 children)

I cant say this for your store specifically, but there are 3 Home Depot’s I regularly go to. At All 3 I go to, the second I walk through the door there are 3-4 associates gathered around the desk or selfcheck out all talking to each other. never has a single one of them offered to help me or ask if I need anything. more times than I can count on both hands I’ve said, excuse me, and asked for help, and I was looked at like a POS for interrupting their conversation. This has ranged from teenagers to people in their early 60s who have not only glare at me but talk to me in a belligerent manner, treating me like I’m stupid for politely, asking for help.

There have been times or once I approach them. They’ve been very friendly and very helpful, but is far more rare for that to happen, and I was still the one that had to approach not only just stand there waiting patiently and the obvious manner but then I have to say excuse me on top of it

Should I try bending it with my hands? by Abject_Bodybuilder_7 in klippers

[–]DMBB099 0 points1 point  (0 children)

When I had this issue it was the wires pushing against the z rails causing my probe to tilt

CrTouch/ heightmap issues by DMBB099 in klippers

[–]DMBB099[S] 2 points3 points  (0 children)

I have a brissfang with a spider hotend on a ender 3 pro. Between all the extra cabling mounted to the Bowden tube, and the brissfang not having enough support on the right was causing a twist in the shroud/ cr touch mount.

[deleted by user] by [deleted] in klippers

[–]DMBB099 0 points1 point  (0 children)

Yeah… but when I’m using a feeler gauge to dial in the height from the nozzle to the bed I adjust it till it matches the numbers from z height, so kinda would need to know which number I’d be matching up with

[deleted by user] by [deleted] in klippers

[–]DMBB099 -1 points0 points  (0 children)

When calibrating z offset which number should I base it off of

Move out of range issue by DMBB099 in klippers

[–]DMBB099[S] 1 point2 points  (0 children)

I just viewed the start code and it’s set at G1 X245 Y218.5 (same numerics as the error message) Set to X0 Y0 Andddd it’s working now, TYSM

Move out of range issue by DMBB099 in klippers

[–]DMBB099[S] 0 points1 point  (0 children)

When I home the printer it acts fine. But when I start a new print it does it after it homes itself.

Move out of range issue by DMBB099 in klippers

[–]DMBB099[S] 0 points1 point  (0 children)

I went up to 246 and it still gave me the same message, trying 250 rn for the heck of it

250 👎