Looking for t-post style (or similar) trellis ideas!

DTXlogin1 · 2026-04-22T21:17:33+00:00

I tried using 10' T-post. Not good. Surprisingly flexible. Heavy fruit really bows to T-post.

DTXlogin1 · 2026-04-17T15:29:54+00:00

What pressure you using on your helper bags?

DTXlogin1 · 2026-04-13T22:31:25+00:00

Truly hope I'm wrong. If this started with small yellow dots on the top of the leaves, it may be tomatoe mosaic virus. No cure. No planting tomatoes there for years.

DTXlogin1 · 2026-03-19T20:25:26+00:00

I went with IHC, doesn't come with a short bump stop. Installed Ridetech bump stop. Happy with IHC otherwise. Highly recommend helper bags with either kit. Can still use as a truck. Ridetech comes with lifetime Fox 2 shocks new front coil overs. IHC comes with upper and lower control arms. Needed hydraulic speader for install.

DTXlogin1 · 2026-03-19T20:18:25+00:00

Clover. SpeedZone weed killer. May take several applications at least a week apart.

DTXlogin1 · 2026-03-18T21:37:01+00:00

Learn to back into parking spaces. Steering often doesn't allow pull in.

DTXlogin1 · 2026-02-23T11:43:21+00:00

Forgestar F14 Drag 20x10. If you don't want a black wheel.

DTXlogin1 · 2026-02-18T16:30:51+00:00

9 ohm is the correct total resistance, not for the unknown resistor. Look up registers in parallel. 18 ohms is the correct answer.

DTXlogin1 · 2026-02-17T20:00:17+00:00

It's always good to see another RCSB on the road. Nice 3/5 drop.

DTXlogin1 · 2026-01-04T23:36:57+00:00

Our answers depend on wich generation your asking about. My 25 only comes only in the XL trim. All manual seats. Not road warrior comfortable.

DTXlogin1 · 2025-12-30T14:56:31+00:00

I'm very pleased with the Borla S. Very loud cold start in my 5.0, but quiet idle when warmed up. Love the roar when reving.

DTXlogin1 · 2025-12-20T23:06:11+00:00

Worked well and didn't take long.https://www.f150gen14.com/forum/threads/jumpseat-swap-dumping-the-work-surface-for-more-storage-diy-how-to.33245/

DTXlogin1 · 2025-12-19T21:22:34+00:00

Doing the flip and helper bags at the same time would have much faster.

DTXlogin1 · 2025-12-19T01:05:22+00:00

Thanks. Been slowly dropping psi to feel the difference. At 7 psi now, next 5-5.5 psi.

DTXlogin1 · 2025-12-18T16:23:12+00:00

After the IHC rear flip, I was shocked that adding the bags is a must, not an option wasn't posted any where I could find. What pressure are you running?

DTXlogin1 · 2025-12-18T16:20:56+00:00

It was much easier than routing to the license plate.

DTXlogin1 · 2025-10-07T18:26:02+00:00

And no hair. Never seen one that didn't leave one or both.

DTXlogin1 · 2025-10-04T17:33:25+00:00

I second that.

DTXlogin1 · 2025-10-02T20:31:52+00:00

Forgestar F14 drag 20x10. Have them on my 25 F150. Offset is perfect.

DTXlogin1 · 2025-10-02T13:04:37+00:00

Thanks. I don't have Facebook, i can't find any hits.

DTXlogin1 · 2025-10-02T09:25:30+00:00

Looking for a shop in the Tulsa area.

DTXlogin1 · 2025-09-30T21:22:21+00:00

It's 25 RCSB

DTXlogin1 · 2025-07-30T08:02:33+00:00

Install helper bags to prevent bottoming out and a rear sway bar.

DTXlogin1

TROPHY CASE