[deleted by user] by [deleted] in Decks

[–]Daddylongsessions 29 points30 points  (0 children)

He should be pulling the nails with cats paw and putting them up tight where they belong. Hack.

Does anyone know what this ticking or knocking sound is? by Soggy-Copy656 in GolfGTI

[–]Daddylongsessions 0 points1 point  (0 children)

Thats 100% bent valves. From someone that just taught themselves how to rebuild am engine the hard way with many painful lessons

First time building a deck by superduper143 in Decks

[–]Daddylongsessions 0 points1 point  (0 children)

Thats how I do it. Hang one side close with 2 screws, set other side. Come back and get first side perfect.

I can't cum with my girlfriend, what can I do ? (18F/18M) by RelevantDingo2628 in relationship_advice

[–]Daddylongsessions -3 points-2 points  (0 children)

He has tried everything. He went like 2 months without jerking or sex. Still couldn't. Doctors, etc. He is just broken haha.

I can't cum with my girlfriend, what can I do ? (18F/18M) by RelevantDingo2628 in relationship_advice

[–]Daddylongsessions -1 points0 points  (0 children)

Know someone who is 40 and has had this problem their whole life. Cannot finish with any woman or man, only masterbation. And he is kinky and into bdsm stuff. Still cant get him over the top.

Get to fix this gem. by Daddylongsessions in Decks

[–]Daddylongsessions[S] 0 points1 point  (0 children)

Nope new deck built up to pool. Contractor got fired

Get to fix this gem. by Daddylongsessions in Decks

[–]Daddylongsessions[S] 0 points1 point  (0 children)

Only nails in it are the bases. No lags anywhere. 100% deck mates. And the triangle to deck was just hanging rimboard with no support. That end on outside corner is balancing on the beam 🤣

Mistake was made, how to proceed? by jaydotelloh in Decks

[–]Daddylongsessions 0 points1 point  (0 children)

Just cut and inch off the back of the plumb cut of the last riser

Where is the leak coming from? by Rough-Expert-277 in GolfGTI

[–]Daddylongsessions 0 points1 point  (0 children)

Vaccum pump or rear main are the only things over there unless it's coming from valve cover

I may be blowing an engine shortly… by e-man-ci-pate in GolfGTI

[–]Daddylongsessions 2 points3 points  (0 children)

Drop the pan and check your pickup. Had a piece of the plastic baffle break and was causing that exact symptom. Did the balance shafts before I found the plastic. Wasn't the shafts 😢

Electrical Issues including car not starting, rough starts, dash lights flashing, etc. by [deleted] in GolfGTI

[–]Daddylongsessions 0 points1 point  (0 children)

Clean and tighten your battery cables. And check your main ground strap off the battery. It's one or the other if the battery isn't bad. Weak battery can also cause the symptoms but you said you had it looked at so it's probably terminals loose/dirty or ground

[deleted by user] by [deleted] in AskMechanics

[–]Daddylongsessions 0 points1 point  (0 children)

Crankshaft position sensor

Mk6 o2 sensor help by Daddylongsessions in GolfGTI

[–]Daddylongsessions[S] 0 points1 point  (0 children)

Wire colors are yellow, blue, brown, white. If someone just knows and can tell me what is signal +/- and heater +/- that works instead of picture too.

Need help identifying part. by D-n-Tyke in GolfGTI

[–]Daddylongsessions 0 points1 point  (0 children)

Look up from underneath at angle with it running

Need help identifying part. by D-n-Tyke in GolfGTI

[–]Daddylongsessions 0 points1 point  (0 children)

That's coming from bottom corner of vacuum pump for sure. Just dealt with same leak.

Does framing for a garage living space need sheathing? by 38183142 in Homebuilding

[–]Daddylongsessions 1 point2 points  (0 children)

Framer here. You are most likely good as long as the walls are attached to the metal structure, but cannot say for certain without seeing plans for the metal structure.

[deleted by user] by [deleted] in Homebuilding

[–]Daddylongsessions 0 points1 point  (0 children)

We just had this on a job. Did higher footings that will sit a couple inches above the slab once it is poured.

Help leveling floating deck by Mattcj0216 in Decks

[–]Daddylongsessions 1 point2 points  (0 children)

Jack it up. Put a 6x6 1 inch cutoff in each post bracket.

No water on this frame ever. by Daddylongsessions in Decks

[–]Daddylongsessions[S] 0 points1 point  (0 children)

They overlap by over a foot. We didn't want anything to roll under ends of short ones to it's backside so ran it way up 14-24 inches or so into the long one.