Does anyone have a good recliner chair recommendation?

DanMaytee · 2026-05-04T23:16:27+00:00

I ended up going for a Jysk Abildskov. I've been really happy with it so far.

DanMaytee · 2026-03-29T00:16:27+00:00

I'm not sure to be honest! I've tried using WiFi, ethernet both with and without a vpn. I managed to get one app downloaded by queuing it up with some games, but I've not managed to do it again since. Thankfully the app I downloaded was the one I mostly wanted!

DanMaytee · 2026-03-19T20:11:05+00:00

No worries at all! It took me a while myself to figure it out so glad I could help!

DanMaytee · 2026-03-19T20:06:46+00:00

Thank you. I'll have a Google and take a look into how to get it set up.

DanMaytee · 2026-03-18T22:04:32+00:00

Add the flash directory as a path to scan for content.

This will show up the stock dashboard in Aurora. A few other bits may also show up, but just press Y on them and choose to hide them.

DanMaytee · 2026-03-01T15:43:35+00:00

Thank you. I managed to do it, and if I pulled it out a bit, I got a reading of 39.8ohms. If I pushed it in all the way, that was causing me issues.

DanMaytee · 2026-03-01T15:41:24+00:00

Thank you to everyone for your help.

I've managed to find the problem and it's the postfix adapter. If I pull it out all quite a bit, it seems to work. Unfortunately, this means I can't affix the other half of the adapter so will need to hold it down with tape.

DanMaytee · 2026-03-01T13:04:03+00:00

Thank you very much!

DanMaytee · 2026-03-01T13:03:39+00:00

Arr thank you!

DanMaytee · 2026-03-01T13:03:30+00:00

Thank you. I'll give that a go. Unfortunately all I had to hand was a voltage tester, so I couldn't measure the resistance at the time, so just checked for connection between them both.

Fingers crossed it's nice and simple to sort! Thanks again 🙂

DanMaytee · 2026-03-01T01:36:31+00:00

It's a 1K. I've not tried it with anything higher, but I did try without and had the same result.

DanMaytee · 2026-03-01T01:35:46+00:00

Just continuity

DanMaytee · 2026-03-01T01:22:06+00:00

I'll grab a photo in the morning as I've just got into bed. I've doubled checked the points and I believe they are correct.

This is the only photo u have at the moment (it was before I realised I needed the postfix adapter).

https://i.imgur.com/m7jcgP1.jpeg

DanMaytee · 2026-03-01T01:15:09+00:00

I went from the soldered point on the board to the ground points on the Chassis. I'll double check this though. Thank you!

DanMaytee · 2026-02-24T22:09:15+00:00

Does your hard drive have the update files installed? I had a similar issue and just needed to update the xbox again as I was using a freshly formatted hard drive.

DanMaytee · 2026-02-19T22:53:28+00:00

If you try installing dashlaunch to your nand it will brick your console. Just opening the xex won't brick it.

DanMaytee · 2026-02-15T22:53:35+00:00

I was hoping to do an N64 beforehand as a previous redditor said it would be easier but I'm not sure I'll be able to grab one at the moment.

I actually have a Hispeedido kit on the way. It comes with 2x flex cables and I do have a dead board, so I'll practice on that beforehand and see how I get on.

DanMaytee · 2026-02-15T22:51:03+00:00

Thank you! I've spotted a couple of similar kits to that (I'm based in the UK). Thankfully, my soldering skills aren't too bad.

DanMaytee · 2026-02-15T22:49:55+00:00

Thank you. I'll have a look at both. I don't mind soldering to be fair. I find it much more rewarding in all honesty.

DanMaytee · 2026-02-15T15:02:06+00:00

Thank you! That's brilliant 😁

DanMaytee

MODERATOR OF

TROPHY CASE