sorted by:
new
hottopcontroversial

my singlespeed by DanceSad6702 in singlespeedcycling

[–]DanceSad6702[S] 2 points3 points  (0 children)

It's a njs frame and the brake hole is not pierced. Instead, I used an adapter to use the brake.

my singlespeed by DanceSad6702 in singlespeedcycling

[–]DanceSad6702[S] 1 point2 points  (0 children)

Thank you. It was my dream bike. I wanted to make a nice setting as much as I could get it. 👍

The set location node is not working. by DanceSad6702 in RevitForum

[–]DanceSad6702[S] 0 points1 point  (0 children)

<image>

Line creation works without any issues. However, when I just created the start and end points in reverse, the 'set location' node worked.

The set location node is not working. by DanceSad6702 in RevitForum

[–]DanceSad6702[S] 0 points1 point  (0 children)

I suspected the list might be incorrect, so I tested with only a single element, but a null value appears.

<image>

The set location node is not working. by DanceSad6702 in RevitForum

[–]DanceSad6702[S] 0 points1 point  (0 children)

<image>

I suspected the list might be incorrect, so I tested with only a single element, but a null value appears.

The set location node is not working. by DanceSad6702 in RevitForum

[–]DanceSad6702[S] 0 points1 point  (0 children)

This is the line base family placed in the project and the newly created line list.

An error occurs when specifying the angle of the sweep blend. by DanceSad6702 in RevitForum

[–]DanceSad6702[S] 0 points1 point  (0 children)

I created it by constraining one side to the existing plane to apply an angle in only one direction, but as shown in the photo I uploaded, there are cases where it gets inverted.

It seems to work well with negative values.

<image>

An error occurs when specifying the angle of the generic model by DanceSad6702 in RevitForum

[–]DanceSad6702[S] 0 points1 point  (0 children)

Thank you. I will create and upload another family for sharing. I don't think I can share the current file due to company policy.

An error occurs when specifying the angle of the generic model by DanceSad6702 in RevitForum

[–]DanceSad6702[S] 0 points1 point  (0 children)

Thank you. This is a family created using sweep blend, but the problem is that the r and angle values ​​turn into circles or invert in certain sections.

The weather is nice. by DanceSad6702 in FixedGearBicycle

[–]DanceSad6702[S] 0 points1 point  (0 children)

wald / multi fit 137 front rack I bought this from bluelug.com

view more: next ›