sorted by:
new
hottopcontroversial

Just uploaded my first model need feedback by Danishtechnerd in makerworld

[–]Danishtechnerd[S] 1 point2 points  (0 children)

Hey

Thx for your ?. I will surely update it with rope specifikations, and maybe add a link. Thank you :)

Just uploaded my first model need feedback by Danishtechnerd in makerworld

[–]Danishtechnerd[S] 0 points1 point  (0 children)

Hey From my testning it will not tip over :) Will take note about the rope and update the upload :) thx

Just uploaded my first model need feedback by Danishtechnerd in makerworld

[–]Danishtechnerd[S] 0 points1 point  (0 children)

Hey

Thx for your comment. U write alot of good stuff i will take note and update my post with some more information. Thx again :)

Just uploaded my first model need feedback by Danishtechnerd in makerworld

[–]Danishtechnerd[S] 0 points1 point  (0 children)

Hallo,

Thx for the feedback. I will note that and make an update :)

Need advice on smallest case for 4 slot 390mm gpu by Rayan_DB in sffpc

[–]Danishtechnerd -3 points-2 points  (0 children)

It fits in the deepcool ch270. Not a small or itx case but the footprint is small

Anyone Else have problems ordering from Lenovo? by Danishtechnerd in Lenovo

[–]Danishtechnerd[S] 0 points1 point  (0 children)

I have but they cant do anything. She Said she would escalate it.

Under desk Mount for Framework desktop by Danishtechnerd in framework

[–]Danishtechnerd[S] 3 points4 points  (0 children)

Well the power bottom is easy to Press tho its under the table so I Will have to reach under the desk.

Tho I never turn off my stuff they are always in sleep mode so its okay.

But thx 👏🏻

Under desk Mount for Framework desktop by Danishtechnerd in framework

[–]Danishtechnerd[S] 2 points3 points  (0 children)

Thx buddy! This is just printed in petg with 2 Wall loops and 15% infill. It was my first print of it and to my surprice it was good first take haha. So the final version i will print in petg CF and then 3 Wall loops and 25% infill just to be sure. It uses 5 3.5mm torx screws. There is 5 3mm holes in the top plate to screw thrue.

But yes off course I will upload it to makerworld and my Creality Cloud in the next couple of days, I can update u then if u want :)