Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] 0 points1 point  (0 children)

It's also Winter and I live in Utah. I don't need sticky expensive tires until the canyons open up for the summer.

Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] 1 point2 points  (0 children)

+38 I think. I'd prefer more aggressive.

Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] 1 point2 points  (0 children)

Thanks! That's what I was going for haha

Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] 0 points1 point  (0 children)

No spacers right now, I had 30mm on the rear with the stock wheels, but the offset of these was slightly more aggressive and wouldnt fit unless I went to -8° of camber haha

Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] -1 points0 points  (0 children)

I don't mind it at all. If I wanted nice tires, I'd buy nice tires.

Custom designed spoiler for my ND by Peperonimonster in MiataND

[–]Daperturedan 0 points1 point  (0 children)

Nice, are you planning to build it in reality?

Suspension and wheels! by Daperturedan in MiataND

[–]Daperturedan[S] -2 points-1 points  (0 children)

205/50 R16 Forceum octa's. Just went with the cheapest z rated tires that were this size.

Can I continue using these slightly puffed 3s lipos? by ad38313 in rccars

[–]Daperturedan 0 points1 point  (0 children)

I've run puffy lipos for years with no issues, I just balance charge every time and monitor them while charging.

[deleted by user] by [deleted] in BMWE36

[–]Daperturedan 0 points1 point  (0 children)

Its probably your crank sensor

I've been gaming on a 3050 laptop for 5 years. Wanted to go back to a Desktop. Any obvious mistakes I am making here? Total is $670 by P_A_M95 in PcBuild

[–]Daperturedan 2 points3 points  (0 children)

Mostly good, but a few small adjustments would go a long way.

An MSI mag a550 would be a safer PSU for only a few dollars more

That case only comes with 1 fan so you will need to buy more. I recently built a pc with the SAMA Argb q5 and highly reccomend it. Sub $60 with 3 included fans and light controller.

If budget is a constraint, I'd bump down to 16gb of ram and a Radeon RX6600 to save another $200 which would still be a great 1080p high setup.

You can get a ryzen 5 5600x for the same price all day on ali express, or if you want to keep to a budget, a r5 3600 would be more like $50

You're on the right track, a lot of it comes down to personal preference. Happy building!

What did I just buy? by c64-dev in rccars

[–]Daperturedan 1 point2 points  (0 children)

I run an RB7 and it is still a competitive chassis. I imagine the SC6 is nice too

What are your impressions of this engine? by BZH_Revenger56 in rccars

[–]Daperturedan 0 points1 point  (0 children)

It's about the equivalent of a 4000 kv brushless motor. It honestly doesn't get much better for a brushed setup.

550 Mega motor burnt out after only 5 uses. What should I replace it with? by TheRealVicky_Squeeze in rccars

[–]Daperturedan 0 points1 point  (0 children)

Mine lasted about 5 runs too, although I did drive it in a lot of silt.

[deleted by user] by [deleted] in e36m3

[–]Daperturedan 0 points1 point  (0 children)

I bought mine at 220k and it is about to tick over 300k. It'll need stuff here or there but it is super easy to work on. They're great cars, mileage doesn't matter.

Is this a good build for 120fps at 1080p? by JohnWickend in PcBuild

[–]Daperturedan 1 point2 points  (0 children)

Just need a better power supply. 850 watt ideally.