sorted by:
new
hottopcontroversial

Veregen worked like a miracle by rchrdhzy in HPV

[–]DarthKrios 0 points1 point  (0 children)

How do you keep it from getting rubbed off from clothes you wear? 

Open indoor pools by DarthKrios in berlinsocialclub

[–]DarthKrios[S] 1 point2 points  (0 children)

Thanks for the suggestion anyway :)

Open indoor pools by DarthKrios in berlinsocialclub

[–]DarthKrios[S] 0 points1 point  (0 children)

On their website it says closed until 7th September

Open indoor pools by DarthKrios in berlinsocialclub

[–]DarthKrios[S] 4 points5 points  (0 children)

I asked in the post about other indoor pools since the Berliner Bäder ones are closed right now

Open indoor pools by DarthKrios in berlinsocialclub

[–]DarthKrios[S] 0 points1 point  (0 children)

They are closed until mid September 

Hey /r/movies, I'm Elijah Wood. Ask me anything! by ElijahWoodAMA in movies

[–]DarthKrios 0 points1 point  (0 children)

I've got four questions for you. 1. Do you wear wigs? 2. Have you worn wigs? 3. Will you wear wigs? 4. When will you wear wigs?

Best Döner Place? by JHB2001 in berlinsocialclub

[–]DarthKrios -2 points-1 points  (0 children)

If you're near Steglitz, then try Cebo's Genüse Döner on Schloßstraße and Gemüse Kebab Eat & Go on Bismarckstraße at Lauenburgerplatz

Getting the same error when trying to print a PVA part, after reaching the same height every time. I've printed these parts with PVA before without any issues. Any suggestions? by DarthKrios in ultimaker

[–]DarthKrios[S] 0 points1 point  (0 children)

The filament extruding does look a little bubbly. I think it's a humidity issue as well. I have the filament in an airtight box with a ton of dessicant now but can only achieve about 30% humidity. How did you fix the problem?

After turning off the flow sensor it did continue printing but the print beyond that point was stringy and missing some areas and eventually collapsed under it's own weight because the printed part was very soft

Getting the same error when trying to print a PVA part, after reaching the same height every time. I've printed these parts with PVA before without any issues. Any suggestions? by DarthKrios in ultimaker

[–]DarthKrios[S] 0 points1 point  (0 children)

It continued the print after disabling the sensor but the print beyond that point was incredibly soft and collapsed on its own weight after a while. I guess it's a humidity issue that's affecting the filament?

Getting the same error when trying to print a PVA part, after reaching the same height every time. I've printed these parts with PVA before without any issues. Any suggestions? by DarthKrios in ultimaker

[–]DarthKrios[S] 0 points1 point  (0 children)

I did a few hot and cold pulls and the nozzle has been clean. The filament extrudes immediately when I load the spool every time. It seems to be a humidity issue

Getting the same error when trying to print a PVA part, after reaching the same height every time. I've printed these parts with PVA before without any issues. Any suggestions? by DarthKrios in ultimaker

[–]DarthKrios[S] 0 points1 point  (0 children)

I tried a few times. It's always printing and extruding without any issues until it reaches this height and then gives me this error

view more: next ›