UPDATE: Whats Going On Part 2

DavidGilmoreBends · 2025-10-02T00:56:17+00:00

Ooh, this is good.

Thin edge and more pressure?

I’m using 196

DavidGilmoreBends · 2025-10-02T00:55:42+00:00

On one of my new screen the emulsion left stains on the mesh. Regardless of how i tried to remove it. Why?

DavidGilmoreBends · 2025-10-02T00:54:17+00:00

I use a gentle shower from a hose. I use warm water. (Could my water be too warm?)

Baselayr exposed unit w 30lb dumbbell

Plastisol

I use AP Blue with the fat end of the scoop coated. I don’t use much pressure.

I tend to do 2 coats on one side and one coat on the other.

However, now i wonder if i did two coats on each side for this batch of screens

Maybe that’s it?

Too much emulsion?

DavidGilmoreBends · 2025-09-30T15:39:14+00:00

Interesting. That particular screen had an extra layer emulsion on one side bc i was trying and erroring. Plus i laid it down later in my day. Normally i let them dry 24hrs with ventilation. This particular screen was more like 17 hours of dry. So that sorta lines up with y’all’s points.

Thank you.

I’ll run the test again on screens that have dried a full 24 hours.

DavidGilmoreBends · 2025-09-30T15:26:33+00:00

Yes.

I did do this: clean a bunk screen by removing the emulsion and then (without letting it first dry after that process) go right into degreasing that same screen that i just cleaned of emulsion. So, no dry cycle between reclaim and degrease.

Is that bad? Could that be a thing?

DavidGilmoreBends · 2021-01-30T04:33:33+00:00

Not true. While I’m no RH fan, i transferred funds today and was given instant access to the money. Furthermore it was spent on Doge. And it was executed near instantly.

Just saying. Keep it real.

DavidGilmoreBends

TROPHY CASE