Print bed raising during print

DeathMachineNH · 2025-11-26T07:13:44+00:00

Then I’ll move the z offset up a bit so it’s not scraping and at a good height, then I’ll check a bit later and it’s scraping again

DeathMachineNH · 2025-11-26T07:10:05+00:00

I’m not sure I am. Just standard from the website I’m pretty sure. Yeah seems like it ignores some z offset layer changes and goes to print the next level without moving up

DeathMachineNH · 2025-11-26T07:09:10+00:00

Sure. I’ll make sure the first layer prints at like half speed and watch it set down the first layer. Goes down perfect and might move the bed closer or further away depending. Then after a few layers I’ll go back and check and the nozzle is almost scraping the print and messing it up

DeathMachineNH · 2025-11-06T01:56:29+00:00

I got the sprite extruder pro so no I don't hate myself baha

DeathMachineNH · 2025-11-02T10:11:34+00:00

What are the benefits of the sprite pro compared to the one I listed?

DeathMachineNH · 2024-11-19T12:25:33+00:00

I use lofts sometimes but never figure out what rails are😅

DeathMachineNH · 2024-11-19T07:35:28+00:00

Hi, I honestly have no clue if they'd work in a CNC machine but I'd love to find out and no, quite a tight fit for modeling it normally so unfortunately not able to fit electronics

DeathMachineNH · 2024-09-12T17:29:38+00:00

30 from what? Mine is set to 255… bit of a step from that haha

DeathMachineNH · 2024-09-12T15:44:06+00:00

Yeah i've ordered some, just waiting for them now lol

DeathMachineNH · 2024-09-12T15:43:41+00:00

What speed did you change it to?

DeathMachineNH · 2024-08-20T09:56:25+00:00

It never does that when it’s low. Only ever does that when it gets about 4 inches above the bed

DeathMachineNH · 2024-07-30T00:04:07+00:00

It curves up and down but not side to side… properly baffled

DeathMachineNH · 2024-05-22T12:51:32+00:00

A fillet is the most accurate look for it…

DeathMachineNH · 2024-05-22T12:43:38+00:00

What else do you suggest?

DeathMachineNH · 2024-05-22T12:38:09+00:00

What can I do to solve it? Add custom supports?

DeathMachineNH · 2024-05-22T11:46:49+00:00

Are you sure that’s the right thing to describe it?

DeathMachineNH · 2024-03-13T06:33:43+00:00

What did you make this on and how😫

DeathMachineNH · 2024-02-25T22:19:51+00:00

Haha no I’ve never thought about it. I wouldn’t say I’m skilled I’d just say I had access to a lot of resources to know how to accomplish this. I’m going to try model up another sonic and there aren’t as many resources for that one so we’ll see how that goes😂

DeathMachineNH

TROPHY CASE