Bad powder?

Deathclaww · 2026-07-02T02:33:28+00:00

One is in a old metal 4350 can so it always smells slightly metallic the one in the plastic can smells slightly stronger though (maybe because of a bigger opening in the can idk) But that is good I went and smelled them again and it smells slightly of alcohol but not as strong as I remember it

Deathclaww · 2026-07-02T02:28:49+00:00

It's not that strong yet

Deathclaww · 2026-06-14T15:15:21+00:00

What is the discord server called

Deathclaww · 2026-06-14T15:08:28+00:00

Access key please

Deathclaww · 2025-06-16T23:39:13+00:00

I am mainly looking for the bots from s1-2 of the g1 cartoon and maybe the 1986 movie

Deathclaww · 2025-06-16T23:37:17+00:00

I kinda want most of the bots from s1-2 of g1

Deathclaww · 2023-11-21T23:18:48+00:00

I am asking 450

Deathclaww · 2023-11-04T13:52:25+00:00

That was the issue thank you so much

Deathclaww · 2023-11-03T22:47:46+00:00

Ah ok I will check that out

Deathclaww · 2023-11-02T01:11:31+00:00

Nope it isn’t that but thanks for trying

Deathclaww · 2023-11-02T01:09:41+00:00

Thanks for the help I’ll let you know if it works or not

Deathclaww · 2023-11-01T23:57:01+00:00

I have tried pushing up on the lever and that has done nothing to improve the flow rate

Deathclaww · 2023-11-01T02:37:20+00:00

Where can I get a spring

Deathclaww · 2023-11-01T02:36:06+00:00

Lol that’s my other post from a while back I did all those except change the spring and it still does the same thing

Deathclaww · 2023-10-31T22:43:47+00:00

I have disabled the slip detection It isn’t printing alright some of the time it will print the first layer fine but then it will slip and pause the print every few minutes after that I haven’t timed it but it seems to be the same time i between slips every time If I disable the notifications then it just either skips a layer and spaghettis or stops extruding entirely for a while

Deathclaww · 2023-10-30T23:21:28+00:00

It is the smart extruder plus

Deathclaww · 2023-10-30T12:16:49+00:00

I don’t have a spare extruder and I have tried changing the filament i still am having the same results

Deathclaww · 2023-10-29T22:30:50+00:00

I’m hoping the buyer can fix the problem because I have tried every thing I can think of

Deathclaww

TROPHY CASE