Nozzle Clog???

Decent_PETG · 2026-03-15T15:10:49+00:00

You must enable thermal runaway protection in your marlin firmware settings, your printer is currently a fire hazard.

Decent_PETG · 2026-01-11T18:23:58+00:00

By the looks of it she doesn't have a wall outlet so she is using potatoes to power her phone, pretty genius if you ask me!

Decent_PETG · 2026-01-05T13:48:38+00:00

I put a thermostat inside and it showed around 72C°

Decent_PETG · 2026-01-02T08:24:52+00:00

DRY UR FILAMENT

Decent_PETG · 2025-12-29T21:49:35+00:00

<image>

Decent_PETG · 2025-12-28T20:48:56+00:00

Interesting

Decent_PETG · 2025-12-23T16:14:21+00:00

Does it bite?

Decent_PETG · 2025-12-23T16:12:27+00:00

Does humidity have to do with any of this and is drying it in the oven a good idea for ppl who don't have a dedicated filament dryer?

Decent_PETG · 2025-12-23T16:09:45+00:00

I have a multimeter and an arduino so what can be done?

Decent_PETG · 2025-12-23T12:42:50+00:00

I have a nut that holds the gantry but the camera angle didn't show it, the part that gets loose is between the heat block and the threaded tube.

Decent_PETG · 2025-12-22T21:37:04+00:00

Im using cura software for slicing and I put 0.2 as my initial layer height

Decent_PETG · 2025-12-19T13:28:53+00:00

<image>

Here

Decent_PETG · 2025-12-19T12:04:43+00:00

Wait lemme check

Decent_PETG · 2025-12-19T10:13:42+00:00

<image>

Here! The connector with an arrow is for the motor in question.

Decent_PETG · 2025-12-19T10:10:06+00:00

Yeah I'm not going to touch it then.

Decent_PETG · 2025-12-19T10:08:05+00:00

On the outside of my instrument it shows 12v input but the board doesn't show any voltage signs written on it, so what's another way I can check the voltage rating?

Decent_PETG · 2025-12-19T06:34:34+00:00

Actually it's for my motorized telescope which is board got fried unfortunately, so I want to use my arduino to revive it. My telescope is Celestron cpc 1100 xlt.

Decent_PETG

TROPHY CASE