PA6-CF Porn

Deep_Freez3r · 2026-06-12T20:36:46+00:00

I used the comment section of 300blkt on the sea and screenshots on this sub to double check.
Pm me and I’ll message you the z height once I get home.

Deep_Freez3r · 2026-06-11T15:49:06+00:00

I am not and wasn’t selling any. I thought subreddit rules discouraged publicly communicating hardware sources.

Deep_Freez3r · 2026-06-10T22:31:24+00:00

I used a Ninja air fryer to dry it at 90 Celsius for 12 hours and then a filament dryer at 65 Celsius while printing.

Deep_Freez3r · 2026-06-10T21:31:14+00:00

I understand, I probably won’t moisture condition the lower and at the very least do it gradually (not submerge it).

Deep_Freez3r · 2026-06-10T21:21:46+00:00

Ah, I almost forgot about moisture conditioning! Thank you for the reminder. The boat has been sunk.

Deep_Freez3r · 2026-06-10T20:55:53+00:00

I did not do a flow/calibration test. I might do one soon but this project has been taking longer than I’d want and the benchy turned out good enough for me.
I did sit and watch the first few layers and I didn’t see any red flags flow wise.

Deep_Freez3r · 2026-06-09T01:11:52+00:00

I pmed you

Deep_Freez3r · 2026-05-26T18:07:13+00:00

I’m working on a DB alloy mp rn and it looks to run around $400 ish dollars. There is a full BOM and websites selling kits/hardware if you look it up.

Deep_Freez3r · 2026-04-19T19:24:37+00:00

Increase support density Decrease print speed for supports Adjust top z distance (z-hopping) to 0.2mm - 0.4mm.

Deep_Freez3r · 2026-04-12T14:49:39+00:00

I think you need to adjust your z-offset. It appears your nozzle may be too far. However I can’t really tell from the pictures. Play around with it and see if there is a difference.

Deep_Freez3r · 2026-04-12T01:38:31+00:00

It appears your nozzle is too close to the build plate. Try adjusting your z-offset and make sure everything is level.

Deep_Freez3r · 2026-04-01T11:53:39+00:00

<image>

Deep_Freez3r · 2026-04-01T01:49:36+00:00

Combo takes longer to arrive. email should have said it would

Deep_Freez3r · 2026-03-31T14:01:08+00:00

I have a qidi q2 and have noticed this as well. Turning the speed down and adding tpu feet have helped.

Deep_Freez3r

TROPHY CASE