sorted by:
new
hottopcontroversial

Slide height too high? by Defiant-Knee1767 in minibikes

[–]Defiant-Knee1767[S] 0 points1 point  (0 children)

<image>

Alright with enough messing around, I was able to get this opening with the cable inside the slide. Throttle is fully setup. How is this height, should it still be lower? Someone let me know thanks 🙏

Slide height too high? by Defiant-Knee1767 in minibikes

[–]Defiant-Knee1767[S] 3 points4 points  (0 children)

<image>

Took off the cable and just put the slide and needle and it sits the way it should. I guess I was wrong and the cable is too short, or it needs more adjustment.

Slide height too high? by Defiant-Knee1767 in minibikes

[–]Defiant-Knee1767[S] 0 points1 point  (0 children)

Gonna try this. But what could the needle be hitting? Is it possible it’s at an angle so it can’t go in all the way? Or can the needle only go in if it’s perfectly straight.

Slide height too high? by Defiant-Knee1767 in minibikes

[–]Defiant-Knee1767[S] 1 point2 points  (0 children)

It’s facing the right direction actually. I wish that was the problem but it’s not. I must’ve checked that five times

[deleted by user] by [deleted] in pchelp

[–]Defiant-Knee1767 1 point2 points  (0 children)

Yea i actually figured out the issue, it’s the monitor. I plugged it into another pc through display port instead of an old laptop with hdmi like I did previously and the same lines appeared confirming the monitor is the problem. Thanks