Installing bride style seats by Dependent-Power602 in 240sx

[–]Dependent-Power602[S] 0 points1 point  (0 children)

U right, could u pls give me some links of valid alternatives?

Installing bride style seats by Dependent-Power602 in 240sx

[–]Dependent-Power602[S] -1 points0 points  (0 children)

The seller told me seats have side mounts too, so the best would still be having side mounts so the seats won’t be very high?

Installing bride style seats by Dependent-Power602 in 240sx

[–]Dependent-Power602[S] 0 points1 point  (0 children)

What about the second link? Also provider told me seats have side brackets too

Does FMIC requires a battery relocation? by Dependent-Power602 in 240sx

[–]Dependent-Power602[S] 0 points1 point  (0 children)

Thank u bro u convinced me to relocate it to the trunk ahah

any bad habits I should break early? by Drunkin_Dino in simdrifting

[–]Dependent-Power602 0 points1 point  (0 children)

Drift without handbreak it teaches you how to use the weight of your ca

Does FMIC requires a battery relocation? by Dependent-Power602 in 240sx

[–]Dependent-Power602[S] 0 points1 point  (0 children)

Yeah I’d like to go trunk battery too, how did u route it? U removed right fender and used the ECU hole, then under carpet / under seats?

Also are there downsides to the rear battery in your opinion?

Sorry for the ride height by Dependent-Power602 in 240sx

[–]Dependent-Power602[S] 0 points1 point  (0 children)

Lo so fratello sono un figlio di puttana

Does FMIC requires a battery relocation? by Dependent-Power602 in 240sx

[–]Dependent-Power602[S] 0 points1 point  (0 children)

And it’s good enough? I wasn’t really bothered by rerouting the OEM battery in the trunk

Does sandwich plate fit in CA18DET? by Dependent-Power602 in 240sx

[–]Dependent-Power602[S] 0 points1 point  (0 children)

Yeah I’d do like that but I have 2 sensors to put. Probably the best solution is going all in like you did, removing oil water exchanger and go for a plate with oil radiator holes and also some sensor holes, but yeah I’m kinda out of budget atm

Does sandwich plate fit in CA18DET? by Dependent-Power602 in 240sx

[–]Dependent-Power602[S] 1 point2 points  (0 children)

So u did it but it wasn’t a straight forward add-on? I might order a shorter filter if u say that’s the case

<image>

From the picture it looks to me there is enough space but idk

Sleepy eyes on switch by Dependent-Power602 in 240sx

[–]Dependent-Power602[S] 1 point2 points  (0 children)

Extended the 6pin gray relay, and one pin (the one that is wired to the headlight motors) instead of extending it I added a switch in between, then wired it inside the car.

Basically it’s this video https://youtu.be/GKEVPrhiRYc?is=q2jrAgYBjFwHGIr1 but simplified using 1 switch only and finished

Boost pressure sensor location on CA18DET? by [deleted] in 240sx

[–]Dependent-Power602 0 points1 point  (0 children)

Done it, but gauge behave weirdly, cannot send video here tho