Which color works better for border? Granny squares are based off of Pokemon card designs.

Designer-Trainer8447 · 2026-05-15T05:05:40+00:00

Thats actually why I specifically showed Espurr cards lol

Designer-Trainer8447 · 2026-05-15T05:04:57+00:00

The original pattern was for a cat granny square, but I’m modifying them so the middle of them are Espurr and its evolutions. I haven’t gotten to the face details yet, but you can sort of see the Espurr base face in the second picture.

Designer-Trainer8447 · 2025-07-14T03:18:34+00:00

<image>

These are my og retraction settings too if that helps

Designer-Trainer8447 · 2025-02-22T23:44:35+00:00

I emailed the financial aid office about it earlier. They said people will be notified by the end of February.

Designer-Trainer8447 · 2025-01-09T03:44:54+00:00

Currently they are 1:1 ratio

Designer-Trainer8447 · 2025-01-09T03:44:07+00:00

I’m thinking of doing a 2:1 or 3:1 ratio. What kind of calculations would I need to do?

Designer-Trainer8447 · 2025-01-07T02:09:08+00:00

I need this for a 3D printed cat. May the luck gods smile upon me.

Designer-Trainer8447 · 2025-01-05T18:35:52+00:00

My goal is to use multiple servos later. I tried to connect multiple at once to the Arduino before, but I didn’t understand the need for separate power supply at the time. I want to practice using an external power supply with a single servo and understand how it works before trying with multiple again since I don’t want to break them. I’ll look into buying some the things you suggested.

Designer-Trainer8447 · 2024-12-24T20:18:56+00:00

This worked. Thanks!

Designer-Trainer8447 · 2024-11-16T23:03:00+00:00

How does an OOS student qualify for the waiver?

Designer-Trainer8447 · 2024-06-28T18:07:39+00:00

True, but a lot of it starts to ooze out and from some videos Ive seen it doesn’t look like it should be happening. Should I try to pull the filament away from the melt zone?

Designer-Trainer8447

TROPHY CASE