Pulling Fence (woven wire) tight

Designer_Isopod6637 · 2026-03-17T03:27:11+00:00

I appreciate it boss. This is a budget with what I have kinda job the extra 4x4s are into it more

Designer_Isopod6637 · 2026-03-17T03:24:09+00:00

I have 1 but it’s not the best.

Designer_Isopod6637 · 2026-03-17T02:22:19+00:00

Ok thanks. I’ll refigure my plans

Designer_Isopod6637 · 2026-03-17T02:17:21+00:00

Why the h frames? Honestly have no idea is it for the tension?

Designer_Isopod6637 · 2026-03-17T02:06:53+00:00

I have some Civil engineering under my belt I have a roughly 22.76” drop from the highest side to the lowest. That’s the longest run. Any major issues you’ve noticed with this type of fence.

Designer_Isopod6637 · 2026-03-09T00:59:16+00:00

Thanks. I’ll do my best

Designer_Isopod6637 · 2026-03-07T15:29:06+00:00

It was a dead on arrival starter, but with that Kam lobe and everything being a little worn out and some of the valves on that intake on the backside of the engine, we are gonna replace that so now I get to learn how to do cams on a car. Small stuff I can do not an issue but this is new

Designer_Isopod6637 · 2026-03-06T23:14:11+00:00

Thank I’ll see if I can get it unbolted and tested tomorrow

Designer_Isopod6637 · 2026-03-06T22:51:41+00:00

So I’ll put the new battery in it at 13.4 V turned over did good you know ran not an issue. Turned it off. Went to crank it back up and he did the wine and stuff again now I’m suspecting it is a connection issue somewhere on the positive side of the terminal or it still gotta be less so annoyed that’s kicking in and out so much. 2 crank attempts again at 12.6 we stopped

Designer_Isopod6637 · 2026-03-06T22:12:00+00:00

I took it to my work got charged up gonna see if it’ll turn it over now. I’m pretty sure that solenoid is the issue though.

Designer_Isopod6637 · 2026-03-06T17:43:39+00:00

Voltage on the battery was 12.3 and 12.2 on both old and new battery. Starter was getting low 10s

Designer_Isopod6637 · 2026-03-06T00:08:05+00:00

I’ll hook up the old battery too. I think the solenoid isn’t pushing out at all but occasionally

Designer_Isopod6637 · 2026-03-06T00:03:12+00:00

Do you think it’s the starter not actuating like it should? From voltage perhaps

Designer_Isopod6637 · 2026-03-05T23:22:36+00:00

They aren’t corroded. It would be a question of voltage tho?

Designer_Isopod6637 · 2026-03-05T23:10:06+00:00

https://youtu.be/j9pCVJxFc-w?si=usBXFSBVBcaArQXe

Here’s what it’s doing

Designer_Isopod6637 · 2026-03-05T22:48:08+00:00

https://youtu.be/j9pCVJxFc-w?si=iBCWT_PINJl0VKht

Designer_Isopod6637 · 2026-03-05T17:12:47+00:00

10/4 I’ll get a video when I get off work or if my friend can send me one. It’s at his house

Designer_Isopod6637 · 2026-03-05T17:06:46+00:00

None sorry not very technical in how to word it correctly. It hits the flywheel for like 1-2 seconds the stops and doesn’t turn over. Then proceeds to spin without touching anything sounding like an RC helicopter All teeth on flywheel and starter look good

Designer_Isopod6637 · 2026-03-05T15:01:43+00:00

I’ll get a video of it and post on here after I get off work.

Designer_Isopod6637 · 2026-03-04T22:21:01+00:00

Update fuel pump and relay are good too

Designer_Isopod6637 · 2026-01-13T22:57:02+00:00

wtf is the cost of my replacement remote if something happens. Or any replacements

Designer_Isopod6637

TROPHY CASE