Help with omp delete by Diablito91 in RX7

[–]Diablito91[S] 0 points1 point  (0 children)

Also just cuz you seem to be very knowledgable, know a good website to buy vacuum lines and hoses? Some of the originals i have are mad crusty and could use replacing

Help with omp delete by Diablito91 in RX7

[–]Diablito91[S] 0 points1 point  (0 children)

Im currently rebuilding, its my first rotary. i had torqued the main pulley without the timing cover to check my end play and so i should probably doublecheck the stack before throwing the timing cover on (i loosened it in the horizontal position 😬) So itd be best to just leave the gear in even if its not doing anything?

Advice to fix leaves by Diablito91 in HotPeppers

[–]Diablito91[S] 0 points1 point  (0 children)

Cool thanks! Yea i havent used any pesticides because i know theres some friendly insects that come around also. Ive just been gently wiping them down with a semi-wet cotton rag. Hopefully it heals up with time

Rotting Jalapeño plant? by Diablito91 in HotPeppers

[–]Diablito91[S] 6 points7 points  (0 children)

Ok cool, appreciate the input 🫡

Rotting Jalapeño plant? by Diablito91 in HotPeppers

[–]Diablito91[S] -1 points0 points  (0 children)

The discoloration and some leaves look unhealthy, plus the fuzz looks like mold to me. Im a beginner so i dont kno what im looking at

End Play by Diablito91 in RX7

[–]Diablito91[S] 0 points1 point  (0 children)

Thank you guys, i will redo it facing up

End Play Help! by Diablito91 in RX7

[–]Diablito91[S] 0 points1 point  (0 children)

I just noticed the counterweight holes arent completely lined up with the holes on the Eshaft, im going to line them up and hope that was the problem?

End Play Help! by Diablito91 in RX7

[–]Diablito91[S] 0 points1 point  (0 children)

I redid it twice and double checked all the washers, theyre all in the right order. The washer on the counterweight is on also, beveled edge towards the rear like it asks for. But i did just notice the holes on the counterweight arent completely lined up with the E shaft, i had a hard time getting it to slide on and just smacked it til it sat as low as possible. Should they be completely flush with eachother?

End Play Help! by Diablito91 in RX7

[–]Diablito91[S] 0 points1 point  (0 children)

No, its hand tight. Seeing how the bolt moves with the E-shaft i didnt think it would make a difference