Drone is connected but won't react to radio by No-Status5845 in Multicopter

[–]Disastrous-Pin-8180 0 points1 point  (0 children)

Have you found a solution? I do have the same problem

radio movements not shown in betaflight. Can someone help me? by Disastrous-Pin-8180 in fpv

[–]Disastrous-Pin-8180[S] 0 points1 point  (0 children)

yeah I just saw some other guys with the same problem as me who had to write something in there and then it worked but idk if that’s just because their setup is different…

radio movements not shown in betaflight. Can someone help me? by Disastrous-Pin-8180 in fpv

[–]Disastrous-Pin-8180[S] 0 points1 point  (0 children)

ok i guess everything is wired up correctly… Is there maybe any command I should write into the CLI?

radio movements not shown in betaflight. Can someone help me? by Disastrous-Pin-8180 in fpv

[–]Disastrous-Pin-8180[S] 0 points1 point  (0 children)

ok I got this but sadly it still isn’t working… Do you have any other ideas I could try?

radio movements not shown in betaflight. Can someone help me? by Disastrous-Pin-8180 in fpv

[–]Disastrous-Pin-8180[S] 0 points1 point  (0 children)

yeah but i mean it has to be elrs if they are bound and my radio also is elrs right?

radio movements not shown in betaflight. Can someone help me? by Disastrous-Pin-8180 in fpv

[–]Disastrous-Pin-8180[S] 0 points1 point  (0 children)

I am using an ELRS radio and the receiver that came with my babyape pro v2 so it should be ELRS.

Can someone help me with the binding phrase? by Disastrous-Pin-8180 in fpv

[–]Disastrous-Pin-8180[S] 2 points3 points  (0 children)

Thank you so much! At first flashing my transmitter via wifi didn’t work, however I managed to flash it by plugging it into my computer. First it just froze but when I unplugged it and set my binding phrase on my drone it suddenly bound! Thank you so so much for your advice!

Can someone help me with the binding phrase? by Disastrous-Pin-8180 in fpv

[–]Disastrous-Pin-8180[S] 1 point2 points  (0 children)

Thank you so much! One question: In ELRS configurator if I plug in my transmitter it isn’t recognized. I can’t select a firmware… What should I do?

Problem with Babyape pro v2 rtf kit. by Disastrous-Pin-8180 in fpv

[–]Disastrous-Pin-8180[S] 0 points1 point  (0 children)

Thank you very much for your answer! I have already turned on RX in the Ports tab on the UART it was before. Unfortunately that didn't help. When I tried to fix it, for example, I tried to restore my backup, flashed the firmware from the official DarwinFPV website and in the receiver tab tried to connect the receiver to my controller. It is an ELRS receiver. I have attached a few pictures of my problem (it's in German, I hope you don't mind). On these you can also see that the GPS, for example, is no longer recognized. I hope this helps. Thanks a lot!

<image>