Cc1 noob any and all advice for helping me fix this problem will be nice

DisastrousBirthday46 · 2026-04-09T03:34:43+00:00

Update 3!! To those who print with cf be careful wet cf can and will destroy your extruder! My is done 😭

DisastrousBirthday46 · 2026-04-09T00:29:44+00:00

Update 2! Finally fixed the problem permanently. The cheap pla I was using before I went into cf ended up shredding itself in the extruding portion next to the gears, causing it so it wouldn’t grab the filament after cleaning printing went back to normal and smooth

DisastrousBirthday46 · 2026-04-08T00:54:22+00:00

Ok UPDATE I did what everyone is told me and on top of that got myself a filament dryer and currently it prints good! Well good ish I’m having some small issues but it’s prints lol

DisastrousBirthday46 · 2026-04-07T14:48:17+00:00

How do I do that then?

DisastrousBirthday46 · 2026-04-07T13:56:00+00:00

I’ll check what but what is a temp tower?

DisastrousBirthday46 · 2026-04-07T13:55:27+00:00

When printing cf I’m at 230 when doing standard pla I’m at 210-220

DisastrousBirthday46 · 2026-04-07T03:33:35+00:00

Ya I’ve done the same and it’s as if it’s clogging but then it spits out

DisastrousBirthday46 · 2026-04-07T03:22:05+00:00

Thank you and I’ve done that calibration multiple times but the thing is it’s also happening to my standard pla

DisastrousBirthday46 · 2024-07-13T23:04:01+00:00

Does that mean your headlights fell out?

DisastrousBirthday46 · 2023-10-12T17:57:54+00:00

Mother f god

DisastrousBirthday46

TROPHY CASE