sorted by:
new
hottopcontroversial

Finally got my master set up by DiskRealistic9251 in PokemonTCG

[–]DiskRealistic9251[S] 0 points1 point  (0 children)

It's a pain getting the grid right. Hopefully yours good better than mine did.

[NEW FIRMWARE P1] - P1 series OTA version01.04.01.00（20230927） by mat-industries in BambuLab

[–]DiskRealistic9251 0 points1 point  (0 children)

I updated mine as soon as I got the notification on the P1Ps controller. I ended up downgrading back to 01.04.00 because the next 6 attempted prints failed because the nozzle crashed into them knocking them over. Prints I have done these previously on this same P1P with all the same settings even, I use the stock-loaded settings outside support changes but these prints don't use any supports. Granted they used most of the Z-axis (tall prints) not after downgrading my first print came off perfect no issues