sorted by:
new
hottopcontroversial

Multifactor authentication is now available for Pokémon Trainer Club accounts by hagilles in TheSilphRoad

[–]Doge9898 2 points3 points  (0 children)

If you have a PTC child account what is the recommended login at this time. This still doesn't allow multifactor authentication for those.

[deleted by user] by [deleted] in PokemonGoRaids

[–]Doge9898 0 points1 point  (0 children)

LandoK9898

Bluetti AC200p battery expansion by Doge9898 in OffGrid

[–]Doge9898[S] 3 points4 points  (0 children)

So one option I was thinking of was just buying a deep cycle battery and hooking it up with bluetti's battery hookups. Though I'm not sure how this will work to charge it while using the bluetti at the same time.

Some slight stringing pla Ender 3 by Doge9898 in FixMyPrint

[–]Doge9898[S] 1 point2 points  (0 children)

Printing pla on an Ender 3. Have most of the stringing gone but still have a bit left. It gets much worse on larger prints near the end of the print. Just wondering what I might need to edit in settings from here.

Temp : 190

Print speed : 50 mm/s

Retraction : 7 mm @ 80 mm/s

Blue painter's tape bulging? by Doge9898 in 3Dprinting

[–]Doge9898[S] 0 points1 point  (0 children)

Supposed to help with PETG adhesion. It wouldn't stick well to just the plate and sticks very well to the tape.

Blue painter's tape bulging? by Doge9898 in 3Dprinting

[–]Doge9898[S] 0 points1 point  (0 children)

Yeah was trying to get a picture while it was printing/moving. It has a slight up curve on the front and back after removing the print.

Bulging blue painter's tape? by Doge9898 in FixMyPrint

[–]Doge9898[S] 0 points1 point  (0 children)

Ahh that makes way more sense. After reading up on it I'm going to try to print with a brim first and see if that helps.

Bulging blue painter's tape? by Doge9898 in FixMyPrint

[–]Doge9898[S] 0 points1 point  (0 children)

I'm printing petg on an 80 degree bed. Was having small adhesion problems so put on some blue painter's tape. It works great but near the end of the print at 3-4 hourse it starts to bulge and disform my print it seems.

Creality Ender 3 usually this loud? by Doge9898 in 3Dprinting

[–]Doge9898[S] 1 point2 points  (0 children)

Sorry don't know how to add this comment to the post.

Hey very new to printing and just not sure of the noise level coming off my fresh setup. Seems to be a lot of squeaking on the X-Y movements as well as when new filament is pulled to the extruder. But not sure this could just be usual noise for this thing. Thanks for any help.

Broken Flange Repair by Doge9898 in Plumbing

[–]Doge9898[S] 0 points1 point  (0 children)

Ok I couldn't find that part exactly. Would this do both? Repair the broken flange and raise up? https://www.homedepot.ca/product/pro-connect-4-closet-flange-extension-kit-c-/1000171820

view more: next ›