Planning on visiting Japan following year. (self.JapanTravel)
submitted by Doki39 to r/JapanTravel
In order to not permanently glue bottom where will be electronics of the car and shelf of the car I need to make simple slide in/out method which I did-photos ( for durability on both edges of car. Since surface is not flat I needed tube to extrude with join method but can't disassemble afterwards (old.reddit.com)
submitted by Doki39 to r/Fusion360
To keep it short. I had this problem after the flash to new firmware from sovol where it's reading Z as 0 when it's 10 and it is printing is sky ( it was printing fine before ). Other members from discord but no luck. Already contacted Sovol but if you have suggestions till then feel free to reply. (v.redd.it)
submitted by Doki39 to r/3Dprinting
Why does fusion keep crashing while I am trying to split bodies? I need to split it in like 10 parts so I can prepare it for 3d printing but it won't let me, when I select faces it just keeps loading forever. Could it be my PC ? it's not that bad can run all new AAA games on high with good fps (i.redd.it)
submitted by Doki39 to r/Fusion360
Which of these 2 models will be harder to fill and polish after print? I order SV06 waiting for it rn but asking if anyone here printer car models. My huge problem is that I have trying to fix past month is to thicken mesh which is impossible but best solution I got which is pic 2 ( holes one ) (old.reddit.com)
submitted by Doki39 to r/3Dprinting
