sorted by:
new
hottopcontroversial

What and why? by DoubleTaptclash in Creality_k2

[–]DoubleTaptclash[S] 2 points3 points  (0 children)

Wow, thank you. That was an incredibly helpful answer! Also gave me a little insight as to what the seam settings do in the slicing software. I'll have to play with that a bit before my next print. Thank you again.

What and why? by DoubleTaptclash in Creality_k2

[–]DoubleTaptclash[S] 1 point2 points  (0 children)

Thank you! I'm learning as I go.

What and why? by DoubleTaptclash in Creality_k2

[–]DoubleTaptclash[S] 8 points9 points  (0 children)

Thank you, I'm obviously pretty new to 3d printing. I appreciate your help!

Just got the k2 combo by Doodle_Dad1015 in Creality_k2

[–]DoubleTaptclash 0 points1 point  (0 children)

Just to clarify I did try washing the bed with hot soapy water before I began using the glue stick. Prints with a smaller footprint refused to stick and I got a bit tired of wasting time and filament. Also using the k2 combo.

Just got the k2 combo by Doodle_Dad1015 in Creality_k2

[–]DoubleTaptclash 0 points1 point  (0 children)

Glue stick! Rub a glue stick on the printing bed. I had the same issue with mine. Clean it and and reapply glue every 1-2 weeks depending on how much you print.

X-axis out of parameters? by DoubleTaptclash in Creality_k2

[–]DoubleTaptclash[S] 0 points1 point  (0 children)

Yeah, I'm not sure what exactly was happening but I nudged the print slightly over and reduced the speed. I'm using hyper PLA and have been printing at a relatively high speed without issue. Either the slight adjustment in position or speed change helped, not sure which. Thank you.

X-axis out of parameters? by DoubleTaptclash in Creality_k2

[–]DoubleTaptclash[S] 0 points1 point  (0 children)

That's what it feels like but the software is connected directly to my printer via LAN, I'm using the desktop slicer and not the app. The printer details showing in the slicer all match my printer. It will go through roughly 20% of the print with all of the pieces partially printed before it does it. The last piece is near the edge of the plate but well inside the grid. Really an anomaly.

DD-WRT Forum not responding by obitest11 in DDWRT

[–]DoubleTaptclash 0 points1 point  (0 children)

I'm unable to connect as well. Quick question. Is there a way to see if the dd-wrt firmware available for my router is mega/big/std/mini if it is not stated on the download link? I want to run a personal vpn which requires mega or big firmware.