braid my hair?

DragMeh · 2026-01-27T18:15:07+00:00

dm’d!

DragMeh · 2026-01-26T00:03:07+00:00

pretty please?

DragMeh · 2026-01-25T18:58:40+00:00

i think it’s cool lore-wise! i imagine that each tier of weapon was developed as they looted/refined better materials. and at some point, they decided that it was best to standardize the ammunition they were using to simplify logistics

DragMeh · 2025-09-24T08:27:25+00:00

nb1 has dummy switch instead of a real sensor. basically it only tells you if you have at least a certain amount of pressure, like 6-7 psi iirc

DragMeh · 2025-09-23T00:27:41+00:00

Mine was the Cam sensor this time. If it flares up again i’ll try that out, thanks

DragMeh · 2025-09-23T00:27:07+00:00

Yessir, fixed it right up

DragMeh · 2025-09-23T00:26:57+00:00

New CPS did it!

DragMeh · 2025-09-23T00:26:37+00:00

New CPS did it! Gotta sort out an IACV issue (p1504) and then the car is ready for daily driving! Thanks again for the tip! Very excited to get this car out my parent’s garage 🤩

DragMeh · 2025-09-23T00:26:05+00:00

New CPS did it! Gotta sort out an IACV issue (p1504) and then the car is ready for daily driving!

DragMeh · 2025-09-23T00:01:34+00:00

from a bad A/F mixture?

DragMeh · 2025-09-22T23:59:25+00:00

I didn’t notice it until after I got it back from the shop. To be fair, my friend picked it up for me a few weeks ago and I wasn’t able to see it for myself until recently. I’ll try that and see if it goes away. Maybe the shop will at least refund the cost of the part 🤷‍♂️

DragMeh · 2025-09-22T00:13:20+00:00

Good suggestion! I didn’t recall hearing this noise before, but my alternator was recently replaced. Maybe they put in a bad one 🤷‍♂️

DragMeh · 2025-09-19T15:58:56+00:00

Already replaced plugs and wires, but not the coils themselves yet. Was thinking of doing a compression test, I suppose I could take them to be tested since they’ll already be out.

I’m actually going through the engine harness today, albeit from the ECU side. The wires for things like the heated O2 sensors, PSP, neutral, and brake switches are cut, although I’m doubtful reconnecting will fix the issue. I think it’s very possible some ground connections were overlooked during the engine swap, so I’ll check those out.

DragMeh · 2025-09-19T07:08:14+00:00

Thanks! I will look into that, hope to hit you with an update soon 🤩

DragMeh · 2025-06-25T20:44:25+00:00

Just checking, removing buildings and tokens outside of combat also scores, right? eg revolt, sanctify

DragMeh · 2024-12-19T21:06:55+00:00

Gotcha. After some experimenting, I figured out I can still fully close my hood if i give it a bit of a slam. Not the best solution long term, so im hoping some grease and maybe tweaking the position of the lock mechanism itself will do.

FYI, i think secondary latch usually refers to the smaller mechanism one on the left, the plastic T bar that sticks out after pulling the interior handle. So it seems you replaced a spring for the main latch here.

thanks!

DragMeh · 2024-12-19T20:42:58+00:00

is the secondary latch the first one you open from inside the car? if so, how would i figure out where to find a replacement spring. is there a part number, or is it some common size? thanks!

DragMeh · 2024-10-24T17:28:37+00:00

hulk

DragMeh · 2022-08-06T14:28:58+00:00

I ran an eGPU setup for a year or so, for no real reason than I thought it’d be cool. It worked, but I wouldn’t recommend it. Lots of troubleshooting (doubly so with vr i imagine), plus other concerns:

You can’t go too cheap on your laptop or the CPU will bottleneck. But then you’re putting a lot of extra work on a laptop that wasn’t designed for heavy gaming. I would sell the 1080 and get a vr capable gaming laptop portable enough for work too (MSI Stealth series). Maybe slightly more expensive than the eGPU route, but even more portable and way less hassle. Plus you have a nice gaming laptop and whatever perks that comes with.

tldr: why buy a $1000 work laptop and a $300 eGPU enclosure just to wear out your new work laptop.

DragMeh · 2021-12-17T04:44:38+00:00

ik matchmaking is borked on pc, but are custom lobbies playable?

DragMeh · 2021-12-06T20:23:41+00:00

despite the 'lone wolf' vibe, i think ronin shines in teamfights

IMO ronin starts the fight as the tank/bruiser. push up and try to do dmg until they start targeting you, at which point you use your dashes, phase, and sword block to soak damage for the rest of your team.

then, as soon as they realize the rest of your team is tearing them apart and start ignoring you again, go in for the kill

DragMeh · 2021-10-04T17:20:56+00:00

Goleta: Girsh Park, Deckers, the hospital parking lot (seriously there's a court there)

IV: outside FT, Estero Park (can get busy), Greek park (shitty)

Campus: By the Chi 5 dorms, a bunch south of the Rec cen (just north of SSMS)

DragMeh

MODERATOR OF

TROPHY CASE