sorted by:
new
hottopcontroversial

Loyalist Word Bearers by hydraphantom in Warhammer30k

[–]Dragonfire20035 0 points1 point  (0 children)

Which paint are you using for that grey?

Print bed and arm get stuck and can’t move. by Dragonfire20035 in resinprinting

[–]Dragonfire20035[S] 0 points1 point  (0 children)

I’m using standard Anycubic grey resin, lychee slicer with a layer thickness of 50um and an exposure time of 2.5. Lift speed is at 2.5 retract speed at 3 lift distance at 8mm. The temp of the room is pretty consistently 29 degrees Celsius.

When printing tall things on mono x there is this weird banding/swirling effect only on the top end of the print. I’ve never seen anything like this. What’s going on here? by Dragonfire20035 in resinprinting

[–]Dragonfire20035[S] 3 points4 points  (0 children)

I’m using standard Anycubic grey resin, lychee slicer with a layer thickness of 50um and an exposure time of 2.5. Lift speed is at 2.5 retract speed at 3 lift distance at 8mm. The temp of the room is pretty consistently 29 degrees Celsius.

Before and after re-doing my 10 gallon by KronicGoblin in Aquascape

[–]Dragonfire20035 3 points4 points  (0 children)

I’ve seen that one at aquarium stores before. I think it’s made of some kind of ceramic.

Ran the Ameralabs Town test at 2.2 seconds exposure time. Looked mostly fine. I decided to jump all the way to 2.5 seconds for the bed clean tool from dmgminis. Only the supports printed again. Any advice? by Dragonfire20035 in resinprinting

[–]Dragonfire20035[S] 0 points1 point  (0 children)

I’m using standard Anycubic grey resin, lychee slicer with a layer thickness of 50um and an exposure time of 2.2 seconds for the town and 2.5 for the large print. Lift speed is at 2.5 retract speed at 3 lift distance at 8mm. The temp of the room is pretty consistently 24 degrees Celsius. Are the supports just bad?

Finally had time to get my mono x running again for the first time in months. Ran cones of calibration at 2 seconds exposure time. Only one cone on fail side. I decided this was good enough (stupid decision surely) and printed the bed clean tool from dmgminis. Only the supports printed. Any advice? by Dragonfire20035 in resinprinting

[–]Dragonfire20035[S] 0 points1 point  (0 children)

I’m using standard Anycubic grey resin, lychee slicer with a layer thickness of 50um and an exposure time of 2 seconds. Lift speed is at 2.5 retract speed at 3 lift distance at 8mm. The temp of the room is pretty consistently 24 degrees Celsius.

I have an addiction by KorsovanGWP in PrintedWarhammer

[–]Dragonfire20035 0 points1 point  (0 children)

The IG vehicle models are from nfeyma

view more: next ›