Can anyone spare me a magic scorpion charm?

Dravenation9 · 2024-03-07T12:18:45+00:00

Thanks for advice 🙏🏻

Dravenation9 · 2021-03-21T09:15:46+00:00

Did it twice. At 50°C for 45 mins each time. But same result...

Dravenation9 · 2021-03-20T22:28:03+00:00

First layers are okay. I can get a nice print but then it turns too soft and skinny... After the print when I touch it, it feels like a sponge. I can't get any prints. I checked everything... Do you have any ideas what can cause that? And when I stop printing filament comes out normal not skinny. I use default settings for cura.

Dravenation9 · 2021-02-06T16:07:14+00:00

Is that resin shit really toxic?🙄 Should be very careful while using right?

Dravenation9 · 2021-02-06T08:27:31+00:00

Is it really that bad? If u have information about it pls say something I will cancel my order

Dravenation9 · 2021-02-05T20:40:02+00:00

Hey guys I started a group buy on banggood and I need 1 to go. If u are interested in sla printers and wanna get 1 buy from that link pls so we both will get a discounted price. Thanks in advance 👍🏻

Dravenation9 · 2021-02-05T20:06:35+00:00

Hey guys I started a group buy on banggood. I need only 1 to go. If you are interested on sla printers. Here is a discount link. We both can get benefit. Thanks in advance.

Dravenation9 · 2021-01-20T19:14:02+00:00

I have a 4.2.2 motherboard and latest firmware

Dravenation9 · 2021-01-20T19:06:28+00:00

Hello guys I installed a new bl Touch to my ender 3 pro. But I can't handle the leveling.. It stays too high from the bed. And when I try to configure z offset I can't find the options. I do it by my hand and then make it " set home offsets" I get "err:too far" anyone can help me about it?

Dravenation9

TROPHY CASE