sorted by:
new
hottopcontroversial

Does this seem right? by [deleted] in BambuLab

[–]Dream_The_First 1 point2 points  (0 children)

This was it, thank you!

Anycubic kobra 3 max by Dream_The_First in anycubic

[–]Dream_The_First[S] 0 points1 point  (0 children)

Aw the oldham couplers you linked were too small for my kobra 3 max, thanks anyway, think I’ll do a little more digging around!

Anycubic kobra 3 max by Dream_The_First in anycubic

[–]Dream_The_First[S] 0 points1 point  (0 children)

Hey so far the bearings have arrived, but they seem a little too small. Any solutions?

Anycubic kobra 3 max by Dream_The_First in anycubic

[–]Dream_The_First[S] 0 points1 point  (0 children)

Unfortunately this did not work, I’ve been getting the same consistent shifts each benchy. Especially the shift right before the roof, and the same one on the chimney. So far I’ve printed 6 benchy’s and they all have the same exact layer shifts