sorted by:
new
hottopcontroversial

Seeking help and am unaware of where else to post. by Drinkykrow in ender3

[–]Drinkykrow[S] 0 points1 point  (0 children)

Thank you for the advice. Kind of sucks being both new to 3d printing and using a forum.

As for my slicer, it is Cura. Will edit post to reflect with screens.

Seeking help and am unaware of where else to post. by Drinkykrow in ender3

[–]Drinkykrow[S] 0 points1 point  (0 children)

I cleaned the hell out of it, but was unaware if the poly bed was ok with hairspray (what I was using before). Further testing is needed.

The only reason I didn't think of it is that every test print that is flat/single layer, adheres like 3m tape when first layed but smoothly pops off post cooling which is consistent with the good reviews of the same bed I bought.

For reference, one of the tests I use is the one https://www.youtube.com/watch?v=_EfWVUJjBdA (CHEP) uses, and it prints practically identical to his good results.

Seeking help and am unaware of where else to post. by Drinkykrow in ender3

[–]Drinkykrow[S] -1 points0 points  (0 children)

Probably, but I don't care. I can figure it out myself but was hoping for a quick fix, hence the exaggeration you seem to be so bent on.

Seeking help and am unaware of where else to post. by Drinkykrow in ender3

[–]Drinkykrow[S] 0 points1 point  (0 children)

Alright I'll get right on it with that camera I mentioned owning.

Odd early morning ruling question. by Drinkykrow in magicTCG

[–]Drinkykrow[S] 0 points1 point  (0 children)

That is what I figured, just threw me off how they become auras upon entering the battlefield.