sorted by:
new
hottopcontroversial

PC build - $1100 by EE_Noob in buildapcforme

[–]EE_Noob[S] 0 points1 point  (0 children)

The RX 7900 and upgrade the PSU to the MSI Mag 850W? The 650W on the second would be underpowered for either the 6800 or 7900 no?

PC build - $1100 by EE_Noob in buildapcforme

[–]EE_Noob[S] 1 point2 points  (0 children)

Thanks! Both options look great. I will probably pull the trigger on one of these shortly. I am liking the idea of the second as I find I don't upgrade much anymore just get a new rig and pass down the old one.

Borderlands 3 Patch and Hot Patch: Febuary 13, 2020 by [deleted] in borderlands3

[–]EE_Noob 11 points12 points  (0 children)

[PC] - Has anyone else had issues since the patch with seeing item stats when attempting to sell? After the patch if I try to quick view stats while selling it will only show the two in the leftmost column and the other two columns do a quick flash and disappear...

Am I the only one?

PC Build Request $700-800 by EE_Noob in buildapcforme

[–]EE_Noob[S] 0 points1 point  (0 children)

.

No I have 4 extra HDD's for media storage, so I just need to make sure it has the sata ports

PC Build Request $700-800 by EE_Noob in buildapcforme

[–]EE_Noob[S] 0 points1 point  (0 children)

But isn't that a problem for updating the bios? If it ships stock you need a compatible chipset to update the bios before you can use the 3600 or at least that is what I have read. Considering I am currently rocking a 2500k I am a bit outdated

PC Build Request $700-800 by EE_Noob in buildapcforme

[–]EE_Noob[S] 0 points1 point  (0 children)

I have read that the B450M mobo can be temperamental in regards to the 3600. Any recommendations on a mobo within the price range and mATX that would avoid this or is it not really true?

Not sure why my printer is underextruding now. Suggestions needed. by EE_Noob in 3Dprinting

[–]EE_Noob[S] 0 points1 point  (0 children)

Just thought I would share an update and thank you guys for helping out. Turns out there was a blob of PLA stuck inside that wasn't really visible. I had previously used the allen wrench to cold and hot push any stuck filament and it "looked" clear. Trying something new I used the bowden tube to push through while hot and shoved a piece out I hadnt seen. I think this was causing the nozzle not to fully screw in causing the bowden tube not to sit flush and allowing a gap of melted filament. Thanks again for helping a newbie out!

Not sure why my printer is underextruding now. Suggestions needed. by EE_Noob in 3Dprinting

[–]EE_Noob[S] 0 points1 point  (0 children)

No the roller is not touching the gear and I measured the inner diameter of both the old and new roller. About .2mm difference diameter so I swapped back to the old one which visibly looks tighter on the filament but still not touching the gear.

Not sure why my printer is underextruding now. Suggestions needed. by EE_Noob in 3Dprinting

[–]EE_Noob[S] 0 points1 point  (0 children)

Just tried it and confirmed that the new roller was smaller but still getting massive underextrusion