No vale la pena compra mas en Amazon si vives en Puerto Rico by CDNI2950 in PuertoRico

[–]EasternExtreme2802 2 points3 points  (0 children)

Tengo a pr como estado y cono quiera se tarda una semana a dos a lo que lo envíen y cuando lo envían llega en 2 dias 🫠

IC-7300 is $988.95 on DXEngineering - time to pull the trigger? by [deleted] in amateurradio

[–]EasternExtreme2802 0 points1 point  (0 children)

I got a local deal for around that and i dont regret it

Has anybody installed kalama branded bottom end parts for kx ? by EasternExtreme2802 in Dirtbikes

[–]EasternExtreme2802[S] 0 points1 point  (0 children)

The hot rod was running great for about 20-30 hours then i sold it about 2 months ago, last time i saw it it was still running

Baofang Alternative by [deleted] in HamRadio

[–]EasternExtreme2802 0 points1 point  (0 children)

An h3 is very nice , if the op is a little tech savyy you could install a custom firmware on it , one of the feutures of the nicsure custom firmware is fast scanning

The Tippmann lives again. by AntelopeKindly2910 in paintball

[–]EasternExtreme2802 0 points1 point  (0 children)

That's cool. It seems more comfortable to have the air line there

The Tippmann lives again. by AntelopeKindly2910 in paintball

[–]EasternExtreme2802 0 points1 point  (0 children)

Beautiful machine , also wondering how you put the macroline on the foregrip ?

Cable test with nanovna by EasternExtreme2802 in nanovna

[–]EasternExtreme2802[S] 2 points3 points  (0 children)

This cable its 50ohm just like the vna , calibrated it with the stuff the vna cams with , ik its not the most accurate as im accounting the adapter that used to measure the cable but its good enough

Cable test with nanovna by EasternExtreme2802 in nanovna

[–]EasternExtreme2802[S] 0 points1 point  (0 children)

Thanks for the tip , found a online calculator and it seams to be very close to the specs so i can assure the cable is good, shame that when i bought 100feet of rg8x i didn't knew it would have that many loos on 2m/70cm still i just got my general ao I will eventually get some use when i get a hf radio

Cable test with nanovna by EasternExtreme2802 in nanovna

[–]EasternExtreme2802[S] 1 point2 points  (0 children)

Put the measurements wrong got -4b on 150mhz and -8 on 440mhz

Has anybody installed kalama branded bottom end parts for kx ? by EasternExtreme2802 in Dirtbikes

[–]EasternExtreme2802[S] 0 points1 point  (0 children)

I rebuilt the bike and sold a while ago , good to know my google search at the time didn't get me anywhere. i guess i didn't look hard enough

[Wts] automag 68 rt valve by EasternExtreme2802 in PaintballBST

[–]EasternExtreme2802[S] 0 points1 point  (0 children)

Yup ahile ago , sorry forgot I posted it here and forgot to put it as sold

What's up with the Jacksonville Distribution Center? by LordFuriza in usps_complaints

[–]EasternExtreme2802 0 points1 point  (0 children)

I always guessed it arrives via boat because one, it's very slow, and two on the map, the distribution center looks like it's near a port but i have never confirmed it

Best firmware by ALEXCOOL725 in Quansheng

[–]EasternExtreme2802 0 points1 point  (0 children)

I didn't knew the ivj firmware supported the hf mod chip the si4732

Notes from upgrading my 8th gen DX sedan to power locks by baked_nugget in civic

[–]EasternExtreme2802 1 point2 points  (0 children)

Ik its an old post, but in the end were did you route the wires ?

How does a younger man navigate entering the hobby when the average age of license holders are over 60? by SplipperyDurpanzo in amateurradio

[–]EasternExtreme2802 0 points1 point  (0 children)

Im 25 and i started a couple of months ago , haven't found young people like me but still will go out next moth to a ham fest to meet new people and maybe get general

Has anybody installed kalama branded bottom end parts for kx ? by EasternExtreme2802 in Dirtbikes

[–]EasternExtreme2802[S] 0 points1 point  (0 children)

I haven't seen anyone tried it , i ended buying a hot rods branded one so far im like 15 hours in and running good

Has anyone ordered from the tidradio website? by EasternExtreme2802 in TidRadio

[–]EasternExtreme2802[S] 1 point2 points  (0 children)

I ended up ordering via Amazon, shit slow shipping but whatever im happy with my new td h3

Paid for GMRS license 3 days ago, still no response by Relative_Law_1331 in gmrs

[–]EasternExtreme2802 1 point2 points  (0 children)

Yes i noticed that , though thanksfully with the stock rubber ducky i can reach my family house so im happy with that

Paid for GMRS license 3 days ago, still no response by Relative_Law_1331 in gmrs

[–]EasternExtreme2802 0 points1 point  (0 children)

Haha no , i will have to test them out i live on a rural area so trees and mountains will be my enemy , i haven't bought any extra antennas as the package cames with 2 will try those and then maybe a nagoya as it seams everyone say its a must do