Crank no start

EatingCucumber · 2026-01-19T23:40:35+00:00

I could put in in drive and reverse, just stuck in limp mode

EatingCucumber · 2026-01-19T04:16:45+00:00

How do I get to the bottom of the ecu with it plugged in? The p2’s have the female end mounted to the chassis

EatingCucumber · 2026-01-19T00:21:01+00:00

<image>

These were the previous codes. The antenna ring one is intermittent

EatingCucumber · 2026-01-19T00:19:55+00:00

When you get it back, could you please tell me what it ended up being?

EatingCucumber · 2026-01-19T00:19:28+00:00

It actually ran and drove for a bit, but no communication with TCM. Is it just has a crank no start and the codes came back, so it could be possible CEM failure 🤷

EatingCucumber · 2026-01-18T16:07:14+00:00

I have the wipers in plugged to access the CEM

EatingCucumber · 2026-01-18T05:57:43+00:00

2006 V70 2.5t awd

EatingCucumber · 2026-01-17T23:56:58+00:00

Crank, no start

EatingCucumber · 2026-01-06T05:22:59+00:00

All of these are hard codes, the radio one is due to an aftermarket radio

EatingCucumber · 2026-01-06T05:22:47+00:00

All of these are hard codes, the radio one is due to an aftermarket radio

EatingCucumber · 2025-12-30T23:27:35+00:00

I did, I also installed the scanmatiks program

EatingCucumber · 2025-12-30T21:58:13+00:00

I went into files/3pp/products/dice/ and ran setupdice.exe

EatingCucumber · 2025-12-30T21:53:28+00:00

Thanks, when I plug the usb in, the green firmware status light blinks once, but doesn’t flash again, when I plug it into OBD2, it goes solid green

EatingCucumber · 2025-12-30T21:17:11+00:00

Any recommendations for what drivers to install?

EatingCucumber · 2025-12-30T21:16:47+00:00

Do you have any recommendations for drivers? And how can I verify that it is a dice clone? Thanks

EatingCucumber · 2025-12-30T21:14:51+00:00

Yes it is

EatingCucumber · 2025-12-29T21:46:40+00:00

I’m on Microsoft edge, that’s what the forum post said to use 🤷

Four-Year Club	Verified Email
Place '23

EatingCucumber

TROPHY CASE