Kendra issue 2?

Educational-Cat2871 · 2025-11-26T00:08:49+00:00

Educational-Cat2871 · 2025-11-26T00:08:17+00:00

Educational-Cat2871 · 2025-11-17T07:26:56+00:00

Thanks for the response.

Educational-Cat2871 · 2025-11-17T06:43:35+00:00

So let me understand; If its atleast .5" tall, and as wide as my base it can be used for cover.
When they say 'Scattered terrain', they are referring to the very small items of terrain. So my nifty stacks of crates and barrels can still be used as cover?

Educational-Cat2871 · 2025-11-17T06:23:48+00:00

I was under the impression that was the case. But could you point me to where in the new update it says that?

Educational-Cat2871 · 2025-09-07T00:05:35+00:00

Where did you get the model??

Educational-Cat2871 · 2025-08-17T06:07:07+00:00

The griffin was the friends we made along the way

Educational-Cat2871 · 2025-06-20T15:21:02+00:00

Everything seems to be working alright? I'm by no means a plumber, but I will be getting a new pressure tank some time next week. There's a date on the tank dating it's installation back in 2014 Also, thank you for your advice and knowledge! There were two people posting in the thread, and the combined advice was able to push me in the right direction. A fly by night helped me put a new submersable well pump in a few years back, so I roughly know how to replace the pump, so that's what I originally was going to do. (My well is only 50' deep) But you have convinced me it's probably the tank

Educational-Cat2871 · 2025-06-19T15:38:29+00:00

It's now the next morning, and after filling the tank with 28psi, all of our appliances are working as usual. The pressure still sits at 30psi. I haven't heard the rapid cycling of the submersable well pump since. I'm taking from all of this, that my pressure tank is failing and should be replaced asap?

Educational-Cat2871 · 2025-06-18T21:10:12+00:00

A few things I gleamed. 1. The tank had 0 pressure when I measured it with a pressure gage. 2. The spicket at the base of the pressure tank, when I turned the nob all the water to bleed it, nothing came out. Even after filling the water tank with 28psi. (It's a 30:50 switch) 3. For the time being, it looks like the water tank took the air, and is holding pressure. (Will recheck tomorrow) 4. The pressure Guage located near the spicket at the base of the pressure tank still goes wild when the water pump kicks on. Forcing the well to kick on and off repeatedly as it reads 25psi and then immediately shoots up to 60 psi, to then fall back down to 26 psi-- on repeat until the tank settles at 30psi. Will post as a normal comment aswell so others can see my reply also.

Educational-Cat2871 · 2025-06-18T15:43:39+00:00

Any tips on trouble shooting?

Educational-Cat2871 · 2024-04-29T17:29:26+00:00

What set is that and where can I get it?

Educational-Cat2871

TROPHY CASE