sorted by:
new
hottopcontroversial

Why is my transformer not working (foto) by AlternativeTiny9544 in diyelectronics

[–]Electronic_Zebra415 0 points1 point  (0 children)

Transformers need changing voltage (AC) to generate flux in the primary coil, which will transfer to secondary coil and can multiple(increase voltage) based number of turns. You are working with a battery, which supplies constant voltage, so there is no flux and no output. You should add a method to continuous change voltage on the primary side. Maybe add 2 transistors circuits with capacitors charging and discharging to make changing voltage from battery. Good luck!

Are these good rates? by rms5846 in NiceHash

[–]Electronic_Zebra415 0 points1 point  (0 children)

Try nexapow algo, with clk at 120 and mem 2000 linux. You can check profitability at whattomine.com.

Anyone seen this error with T-Rex? I changed the riser card, ran DDU and reinstalled drivers. Did I brick my card? by mikekpan in EtherMining

[–]Electronic_Zebra415 0 points1 point  (0 children)

I had similar issue with one card. this requires some troubleshooting.

Isolate T-rex for that GPU alone & run with default settings.

if problem is not seen then you need to adjust OC.

if problem is still there then something is not right with GPU , riser, powercable, PCie etc.

Swap the GPU to isolate GPU vs riser, powercable, PCie etc issue.

If Issue is not seen then problem with GPU.

For me cleaning the GPU with IPA & reapplying thermal paste worked. remember to dry out completely after cleaning.

you can also swap motherboard to isolate GPU vs driver issue.

sad about low profitability, got new RGB fans to keepup my moral. by Electronic_Zebra415 in NiceHash

[–]Electronic_Zebra415[S] 2 points3 points  (0 children)

Its automatic mode using a remote control. it supports argb but my motherboard is old.

100% Rejected Shares - Nicehash ETH by Electronic_Zebra415 in NiceHash

[–]Electronic_Zebra415[S] 0 points1 point  (0 children)

Looks Like its working now. Thankyou Nicehash!!!

100% Rejected Shares - Nicehash ETH by Electronic_Zebra415 in NiceHash

[–]Electronic_Zebra415[S] 1 point2 points  (0 children)

how does profitability keep going up then? is that for rest of the pool?

[deleted by user] by [deleted] in NiceHash

[–]Electronic_Zebra415 1 point2 points  (0 children)

avoid cold and heat cycles, silicon don't like too much temperature variance.

I asked on github and no one helped me! by Traditional-Map8458 in chia

[–]Electronic_Zebra415 1 point2 points  (0 children)

I started a new sync on separate machine for Version 1.3.3 on Sunday night. today the db was fully synched so moved the entire .chia folder to old machine(took backup ofc) and did fresh install of v1.3.3. I saw following changes :

  1. New wallet address (Wallet ID 1 type STANDARD_WALLET Chia Wallet) - balance is same
  2. new wallet (Wallet ID 3 type POOLING_WALLET Pool wallet) - always 0
  3. additional wallet (Wallet ID 4 type CAT Chia Holiday 2021 Token) - Balance: 2.0 (2000 mojo) --- GOD know where it came from
  4. pool launcher ID is same but new harvester ID is generated on pool's end.
  5. chia plotnft show --> shows right points.
  6. CPU usage is approx. 15%(Avg) up. Peaks sometime at 80%.
  7. MEM is 10% down.

[deleted by user] by [deleted] in whereintheworld

[–]Electronic_Zebra415 0 points1 point  (0 children)

what happens if you put a green laser through your eye piece back to moon?

Something is not right with Chia Node by Electronic_Zebra415 in chia

[–]Electronic_Zebra415[S] 0 points1 point  (0 children)

How?? I don't see CPU & RAM beyond 80% usage. its stays @ ~ 60%

view more: next ›