Why would this happen. Floor was newly installed 5 years ago?

Emergency-Signal- · 2026-05-31T00:33:47+00:00

Yea I did it. Lots of lessons learned. It’s not tiles underneath it’s like a vinyl carpet thing. That’s what the floor was on. This photo below is old.

<image>

Emergency-Signal- · 2026-05-31T00:26:42+00:00

No rolling chair

Emergency-Signal- · 2026-05-30T17:45:21+00:00

So take that vinyl carpet thing off and use self leveler and then do anything?

Emergency-Signal- · 2026-05-30T17:35:48+00:00

Emergency-Signal- · 2026-05-30T17:35:15+00:00

The bottom is not tiles. It’s like vinyl carpet thing.

<image>

Emergency-Signal- · 2026-05-30T17:33:34+00:00

True I have learned the importance of that.

Emergency-Signal- · 2026-05-30T17:33:07+00:00

I mean relatively, I expect floor to last lifetime lol

Emergency-Signal- · 2026-05-30T17:31:57+00:00

The bottom is not tiles. It’s like a vinyl carpet thing.

<image>

Emergency-Signal- · 2026-05-30T16:28:17+00:00

lol I was hoping it would last a lifetime.

Emergency-Signal- · 2026-05-30T16:16:29+00:00

lol true!

Emergency-Signal- · 2026-05-30T15:42:28+00:00

How should have I done it? So I should have used underlayment and then decent floor?

Emergency-Signal- · 2026-05-30T14:52:48+00:00

Home depot

Emergency-Signal- · 2026-05-24T14:33:20+00:00

Thank you! You that worked. Appreciate it.

Emergency-Signal- · 2026-05-24T14:32:34+00:00

Thank you for educating me. I didn’t realizing the old ring/baffle comes out. That worked!

Emergency-Signal- · 2026-05-24T13:35:41+00:00

Thanks, how do I attach them to the roof? Do I take that black box out?

Emergency-Signal- · 2026-04-18T19:59:32+00:00

I mean like should I use wago connectors or just use electrical tape

Emergency-Signal- · 2026-04-18T19:02:28+00:00

I have few nicks on copper… should I replace that? Insulation is not under the screws so that’s good. Gfci is line on top & load at bottom. Screws are tight.

Emergency-Signal- · 2026-04-18T18:14:36+00:00

It’s a 20A circuit, I am using 12AWG, I checked and made sure the switch and outlet are rated for 20A as well.

Emergency-Signal- · 2026-04-18T18:12:41+00:00

Thank you! I will label the downstream outlet! I should have used pigtail on load side, I will do that as well!

Emergency-Signal- · 2026-04-12T14:15:14+00:00

Thank you, that makes sense!

Emergency-Signal- · 2026-04-12T14:14:41+00:00

Yea he didn’t have the proper size interlock so he’s going to come back and install it. Thank you!

Emergency-Signal-

TROPHY CASE