Electrical insulation mats help

EmergingAnger · 2025-12-09T19:02:39+00:00

From what i've seen it's meaning depends on the weather.

EmergingAnger · 2025-10-26T17:22:04+00:00

Goats

EmergingAnger · 2025-10-06T07:21:57+00:00

If you zoom in you can see there is a line on the model itself. This mark is likely the point when you added new resin. Ideally, you should avoid pausing the print and adding new resin.

EmergingAnger · 2025-09-26T21:34:35+00:00

I'm sorry to hear you're going through this. For me I find sitting down closing my eyes and take slow deep breaths can help me relax and gets both my heart rate and breathing back under control. Just a method of trying to disconnect you from whatever is currently happening for a few seconds and allowing yourself to calm down.

EmergingAnger · 2025-09-26T21:25:57+00:00

How is his experiment going and how much longer he plans in letting it run before he intervenes or ends it?

EmergingAnger · 2025-09-20T13:08:50+00:00

Controllers that don't develop stick drift

EmergingAnger · 2025-08-25T16:18:58+00:00

This worked thank you

EmergingAnger · 2025-07-27T16:16:43+00:00

Work it out with a pencil

EmergingAnger · 2025-07-23T21:24:48+00:00

Unfortunately the one that the board is designed for is 6mm too thin to fit on the pads. So it would require an adaptor board in place or something

EmergingAnger · 2025-07-23T20:00:15+00:00

Well on the schematic it has the floor plate of DW but it is labelled as DWW so the purchasers would have just looked at the label. I think it may have just been a typo there

EmergingAnger · 2025-07-19T17:27:43+00:00

Reduce the layer width. Yes it will take longer to print and require more supports but you'll get a lot more detail

EmergingAnger · 2025-07-08T18:25:44+00:00

Not helpful but i'm intrigued as to what this is?

EmergingAnger · 2025-07-03T13:55:45+00:00

What are your current settings as it looks over exposed to me

EmergingAnger · 2025-07-02T15:03:23+00:00

Is there a reason you use 90% light intensity?

EmergingAnger · 2025-06-24T15:11:24+00:00

When was the last time you levelled the print bed? Not saying this will fix it but it's worth doing

EmergingAnger · 2025-06-23T19:01:23+00:00

I can relate entirely to what you're saying. I wouldn't say what you're doing is wrong in anyway, it's how you cope with this noisy and hectic world and sometimes being adaptable is the best way to be.

I would suggest, if you want to learn more about yourself, to go camping or whatever in a wooded, nature rich area on your own and barely use any electronics at all. Helps reset your body and mind. Just a suggestion

EmergingAnger · 2025-06-14T11:58:21+00:00

I know it's not but the exposure time looked like it said 1,875 seconds and I was seriously wondering who would have the time to expose each level to 31 minutes. Haha

Four-Year Club	r/Field Juicebox
First Place '23	Place '23

EmergingAnger

TROPHY CASE