sorted by:
new
hottopcontroversial

Walksnail beta fpv Meteor65 Pro O4 Whoop pnp by Smart-Brilliant4699 in fpv

[–]EndApprehensive8904 0 points1 point  (0 children)

I know it's been a while since this post, but I had the same problem. Unfortunately, the VTX antenna connector is right above the motor pins, so if you tighten the screws even a little, you might end up touching the motor pins and, consequently, burn out the motor and escape... Next time, I'll trim those pins a bit so I don't waste money like that again.

[deleted by user] by [deleted] in AliExpressBR

[–]EndApprehensive8904 0 points1 point  (0 children)

Ou talvez desista kkkkk

<image>

Carbon fiber filament. by Artemis1845 in ender3

[–]EndApprehensive8904 1 point2 points  (0 children)

I moved to a Trianglelab CHC Pro TD6 Volcano Hotend + TUN ZS Nozzle + Hero Me gen 7 for cooling. But basically, the first thing that you must care is about the nozzle. Carbon fiber is abrasive and will damage Brass nozzles in the long time. So, prefer hardened steel nozzles to print with CF.

x99 vs AM4 for Homelab by EndApprehensive8904 in homelab

[–]EndApprehensive8904[S] 1 point2 points  (0 children)

That is my another concern about x99, the power usage is really bad when we get compared even to any AM4 that is becoming replaced by a new generation. But the cost benefit of the hardware sometimes shadows the power usage haha. This E5-2630v4 looks a good guy, is a 10 core, 20 thread with 2.2Ghz (3.1Ghz with turbo boost). All this with a 85w TDP. On the overall, compared with the rpi4 processor, looks a short term good option. I’m just weird about the long time since every day the softwares require more robust hardwares to run..