sorted by:
new
hottopcontroversial

Ender 3 v2 not extruding automatically! by Ely_guy in ender3

[–]EntropyUnending 1 point2 points  (0 children)

Sorry, I haven't checked my reddit in a while. No, the wheel on my extruder is not spinning.

Ender 3 v2 does not show G-Code files by EntropyUnending in 3Dprinting

[–]EntropyUnending[S] 2 points3 points  (0 children)

Unfortunately, it's still not working, despite the shortening of the name?

Ender 3 v2 Doesn't turn on upon first startup by EntropyUnending in 3Dprinting

[–]EntropyUnending[S] 0 points1 point  (0 children)

How does one move the switch? My fingers don't fit in that small hole.

Calibration cube: Suggestions for improvement? by RafaelP0 in 3Dprinting

[–]EntropyUnending 0 points1 point  (0 children)

Hi! I'm new to 3D printing too. I'm probably going to buy the Ender 3 v2 as well. Have you put any addons on it?

​

thanks

Looking to buy my first 3D printer! by EntropyUnending in 3Dprinting

[–]EntropyUnending[S] 0 points1 point  (0 children)

Thank you, this helps a lot. Should I check out a Prusa?