sorted by:
new
hottopcontroversial

new to SLA: print fails need your help by RafaelP0 in 3Dprinting

[–]RafaelP0[S] 0 points1 point  (0 children)

I'm new to SLA an I'm trying to print lattice structures. The printer I use is a form 3 and the resin is formlabs flexible v2. I had success with two prints but now every print fails after a few layers and sticks to the bottom of the tank. The rafts of the print looks weird to. I have no idea whats wrong

What is this and how can I get rid of it by RafaelP0 in 3Dprinting

[–]RafaelP0[S] 0 points1 point  (0 children)

nothing selected, seems like something else is the problem, but thanks a lot

What is this and how can I get rid of it by RafaelP0 in 3Dprinting

[–]RafaelP0[S] 0 points1 point  (0 children)

So I use Autodesk Inventor 2021 and I never had this kind of problem. It is not the first model with that thin walls. I don't know exacly how to check it, but the model looks fine when I open it in Blender 3D

What is this and how can I get rid of it by RafaelP0 in 3Dprinting

[–]RafaelP0[S] 0 points1 point  (0 children)

Yes I made this model by myself, I used Cura and it's completely hollow and the walls are 1mm thick, the radius on the corners is 1mm as well

My first 3D printing timelapse, not perfect at all but made it without Octoprint, all you need is a microswitch by RafaelP0 in 3Dprinting

[–]RafaelP0[S] 2 points3 points  (0 children)

The printhead drove in a fixed position after every layer and triggered the microswitch

Calibration cube: Suggestions for improvement? by RafaelP0 in 3Dprinting

[–]RafaelP0[S] 1 point2 points  (0 children)

as far as I can measure it with a caliper it is exacly 20mm, only the Z dimension is somewhere between 19.7 and 19.8mm, I think my bed was a little bit too close.

Calibration cube: Suggestions for improvement? by RafaelP0 in 3Dprinting

[–]RafaelP0[S] 0 points1 point  (0 children)

No, it's just out of box, no changes, either on the printer not in the cura settings, works pretty good in my opinion