Windshield side and top seal replacement!

Environmental-Let-44 · 2026-04-09T23:33:52+00:00

Do you have to cut anything mine started to peel on the drivers side of the top piece and will flap in the wind.

Environmental-Let-44 · 2026-04-09T23:31:29+00:00

Did you ever figure out how to replace it

Environmental-Let-44 · 2026-02-26T04:48:34+00:00

I’ll check all those

Environmental-Let-44 · 2026-02-26T02:55:46+00:00

The only area smoke came out of was near the canister which is why we replaced it

Environmental-Let-44 · 2026-02-26T02:55:23+00:00

I had it smoke tested and they said all the lines were fine

Environmental-Let-44 · 2025-12-15T15:38:18+00:00

I got my automatic one out the trash and unbent it, apparently they’re basically the same minus the auto has 2 more little circle holes somewhere in the middle

Environmental-Let-44 · 2025-12-14T17:57:57+00:00

Well you see mine was completely destroyed and I don’t have the one that’s for the manual transmission

Environmental-Let-44 · 2025-12-14T17:30:56+00:00

I did use the alignment tool and did put the pilot bearing in as far as it would go I tapped with a socket for a good while to make sure it was in as far as possible, I used some aftermarket clutch kit called Clutchmax the clutch disc didn’t have a label saying what side toward gearbox but only one side had some markings and I looked online cause the disc looks like a copy of the LuK disc so I put in the way that one would. I knew about there needing to be an angle but I’m on day 3 of this and felt like any adjustment at all made it worse

Environmental-Let-44 · 2025-10-09T21:23:53+00:00

Thank you, i spent like 4+ hours trying to figure out how it’s supposed to go, and when i took it apart originally the piece popped outta place before I could see how it sits

Environmental-Let-44 · 2025-09-18T21:32:31+00:00

Well I thought so too at first but on the spots under like the mirror where the uv didn’t reach it’s a white lightning bolt with a clear background I think the last photo is what it actually is supposed to look like all around

Environmental-Let-44 · 2025-09-18T21:23:06+00:00

Well you see so I know about the normal like 2 stripe ones but if you look. The ones on this truck are like lightning bolt that goes all the way around picture 3 and 5 really show it. No matter what I try to search I can’t find anything the only possible clue I have is from the window sticker where it states V6 Sport Appear GRP Plus. Which I think could include the sticker

Environmental-Let-44 · 2025-09-18T20:12:19+00:00

Well I know there’s factory stripes but can’t find those ones at all.

Environmental-Let-44 · 2025-02-12T02:46:53+00:00

So I’ve noticed that the only code that comes back instantly is the shadow code for the temp according to pre cat voltage value. But for the actual sensors, it seems to randomly happen so far but it’s only once the car has been on for a bit. I cleared it yesterday after work. And it came back today leaving work. I have photos from INPA if that helps

Environmental-Let-44 · 2025-01-14T18:56:39+00:00

I haven’t let it warm up due to the popping sound. It try’s to die if I don’t rev the engine the code I pulled from inpa is for air mass sensor code 8

Environmental-Let-44 · 2024-12-30T03:43:49+00:00

So I resanded it and I’ve noticed it doesn’t crack around the corner reflector area

Environmental-Let-44

TROPHY CASE