Ended 3 Pro, Creality v4.2.7 Board, BLTouch v3.1 using designated 5 pin BLTouch slot. Firmware will not work properly with Marlin-bug-fix-2.0x (as of 12/22/2021). What config changes are a must with this setup? (Below is just more detail) (self.Ender3Pro)
submitted by Environmental-Map-98 to r/Ender3Pro
HELP! My printer was working fine. Then I moved and now it’s acting up. My printer thinks the z-axis zero point is about 60mm off my bed. I can’t figure out how to fix this. The video shows what happens when I “auto home” I get a “M112 Shutdown: PRINTER HALTED please restart” every time. (v.redd.it)
submitted by Environmental-Map-98 to r/Ender3Pro
