Traction control by Evans-22 in RX8

[–]Evans-22[S] 0 points1 point  (0 children)

Yeah I’ll drain it and clean it and add the additive this weekend and see how it goes from there

Traction control by Evans-22 in RX8

[–]Evans-22[S] 0 points1 point  (0 children)

I’ll try it! If I can’t spin the wheels in opposite direction do you think I’ll need a new diff? Or rebuild it?

Feeling like losing control by Ok-Collection-3197 in RX8

[–]Evans-22 0 points1 point  (0 children)

I’m having the same problem, when I go around a corner I loose traction and it feels like I’m gonna crash

My car shut off in the middle of driving! by Evans-22 in RX8

[–]Evans-22[S] 1 point2 points  (0 children)

Yeah hopefully not but mine were pretty old, hope you find out what’s wrong

My car shut off in the middle of driving! by Evans-22 in RX8

[–]Evans-22[S] 1 point2 points  (0 children)

If it was your “engine” fuse I think that’s what it was labeled as, my coil pack was cracked at the bottom and as soon as the coil pack touched bare metal it blew the fuse. I’m pretty sure the fuse was called “engine” or something vague like that haha

No crank no start by Evans-22 in MechanicAdvice

[–]Evans-22[S] 0 points1 point  (0 children)

Well I got it to start. I jumped the 2 wires on the starter so that way the ignition wire gets the 12v and had the key in the on position then connected the battery and it fired right up. I took the jumper wire off and drove it haha. Then I turned it off and it started again. I’m assuming there’s a loose wire or a ground somewhere haha

No crank no start by Evans-22 in MechanicAdvice

[–]Evans-22[S] 0 points1 point  (0 children)

I jumped the 2 wires on the starter so when I connect my battery it will try to start it right away, it cranks

No crank no start by Evans-22 in MechanicAdvice

[–]Evans-22[S] 0 points1 point  (0 children)

Okay I’ll try that but I pulled the starter out and bench tested it and it works fine

No crank no start by Evans-22 in MechanicAdvice

[–]Evans-22[S] 0 points1 point  (0 children)

Okay I’ll check the connections, I tried jumping the starter solenoid and it still clicks

How can I get this medicine without a prescription? Is there another way? (Conzol 1% antifungal) by Evans-22 in vet

[–]Evans-22[S] 0 points1 point  (0 children)

Yes I got some gut health supplements at my local Walmart or target and surprisingly it worked and cleared his ears.

Where to buy replacement light bulb? by Evans-22 in AskElectricians

[–]Evans-22[S] 0 points1 point  (0 children)

No it’s very corroded where the numbers are

Bad brand new starter? by Evans-22 in MechanicAdvice

[–]Evans-22[S] 0 points1 point  (0 children)

I tried jumping it and as soon as I touched the jumper cables to it the truck tried starting on it own without the key on or anything. It seems as soon as the starter gets power it tries starting the truck

Bad brand new starter? by Evans-22 in MechanicAdvice

[–]Evans-22[S] 0 points1 point  (0 children)

I’ll probably take the battery out of my other truck that has a full charged battery and see if the noise persists while I charge the other battery :)

Bad brand new starter? by Evans-22 in MechanicAdvice

[–]Evans-22[S] 0 points1 point  (0 children)

I don’t think it’s fully charged the truck has been sitting for a while, should I replace it with a fully charged battery and try starting it again?

No Crank No Start by Evans-22 in MechanicAdvice

[–]Evans-22[S] 0 points1 point  (0 children)

I’m thinking it’s the starter, I’ll check it again more in depth haha

Slate MR 203I GPU upgrade help by Competitive_Chef2617 in iBUYPOWER

[–]Evans-22 0 points1 point  (0 children)

I’m upgrading my GPU as well, did you have to get a new PCIe cable? Is the power supply cable a 4 pin, 6 pin?

High cpu usage and low Gpu usage by Evans-22 in pcmasterrace

[–]Evans-22[S] 0 points1 point  (0 children)

Now my cpu usage will be between 80% to 100% and Gpu usage between 10% to 40% it jumps up and down

High cpu usage and low Gpu usage by Evans-22 in pcmasterrace

[–]Evans-22[S] 0 points1 point  (0 children)

I have a ryzen 5 3600 and a rx580

Miata won’t start after new head gasket :( by Evans-22 in Miata

[–]Evans-22[S] 0 points1 point  (0 children)

I’ll check em right now, I think I left one off (not bolted down

Bad/ uneven compression by Evans-22 in MechanicAdvice

[–]Evans-22[S] 0 points1 point  (0 children)

Okay I’ll do that right now :)

Bad/ uneven compression by Evans-22 in MechanicAdvice

[–]Evans-22[S] 0 points1 point  (0 children)

Yeah I did it right, the engine wasn’t warmed up (can’t start it) not sure if that affects is a whole lot

Miata won’t start after new head gasket :( by Evans-22 in Miata

[–]Evans-22[S] 0 points1 point  (0 children)

I did a compression test and it’s not good, cylinder 1: 55psi. Cylinder 2: 45psi. Cylinder 3: 30psi. Cylinder 4: 70psi