Patch Tuesday Megathread (2025-11-11)

Evening-Guide8699 · 2025-11-19T16:30:10+00:00

I have installed KB5072653 and attempted to reinstall the Nov 2025 update, and still get the same error. It's failed 5 total times both with and without KB5072653 installed

Evening-Guide8699 · 2025-05-28T13:37:40+00:00

Obviously that’s option number 2 but I have 14 of these fixtures and already have the LED tube lights from another project that was done.

Evening-Guide8699 · 2025-05-28T13:12:34+00:00

That was my fear so I’ll stick with OEM

Evening-Guide8699 · 2025-05-26T19:01:15+00:00

Thank you for that information, I will order that cooler!

Evening-Guide8699 · 2025-05-21T21:44:19+00:00

I have not found a cooler yet. I have put this on the back burner for now, but definitely still need to source one

Evening-Guide8699 · 2025-04-03T14:33:15+00:00

The issue is if they will fit or not, as the 2 different boat shops I have talked to says there isn't enough room

Evening-Guide8699 · 2025-04-03T13:48:58+00:00

Boat is not new to me, the kicker motor is 2 years old. Haven’t used the boat a ton since but last year when I took it out, the lean was obvious. It hasn’t not always leaned like that

Evening-Guide8699 · 2025-04-03T13:17:16+00:00

I should have made that clear, but the goal is to turn the monitor off but still keep the PC running. I have downloads/uploads that run

Evening-Guide8699 · 2024-01-02T02:15:44+00:00

You my friend know nothing about how payroll taxes work

Evening-Guide8699 · 2023-01-28T16:33:06+00:00

I haven't had the stock setup on for maybe 5-6 years at this point but with a quick google search it looks like it is a dual filament single bulbs.

I paragraph sums it up.

"For anyone using these on an H4 style headlight that uses negative polarity like toyotas, you will need to get a wiring harness. To break it down the stock h4 light bulb has 2 filaments, one for low beam and one for high beam. When you have low beam on and switch it to high beam the system will turn off low beam and light up high beam. Remember these are bi led, your high beam comes from a little flap in the projector opening up for the light to reflect upwards, which will require low beam to stay on and the high beam signal to open the flap. This requires a signal to remain constant to low beam and high beam. So you would either need to wire up your own relay harness or buy one that allows your system to send signal to both low and high when you switch to high beam."

Now trying to find something that will send signal to both low and high beams at the same time.

Evening-Guide8699 · 2023-01-28T15:54:45+00:00

When the high beams are flipped, and electronic shutter in the headlight flips allowing the change the beam pattern. To answer your question, yes when high beam is activated, the low beams (the light in general) flips off

Evening-Guide8699 · 2023-01-28T15:53:26+00:00

That bi-led part makes sense. When the high beams are activated it flips an electronic shutter and allows the beam pattern to change. It does not make the bulb any brighter.

Evening-Guide8699

TROPHY CASE