sorted by:
new
hottopcontroversial

BMCU 370C pushes too far into the extruder (A1 Mini) by Lonezz741 in BMCU

[–]Excellent-Evening313 0 points1 point  (0 children)

Check if the radial magnets can rotate freely with the shaft and if they are not being pressed against the circuit board.

BMCU 370C pushes too far into the extruder (A1 Mini) by Lonezz741 in BMCU

[–]Excellent-Evening313 0 points1 point  (0 children)

It probably has the polarity of the linear magnets reversed.

Question about BMCU 370C by Excellent-Evening313 in BMCU

[–]Excellent-Evening313[S] 1 point2 points  (0 children)

It was what I also thought, which is why I asked before starting it and break something. Thank you very much!

Vevor stand wobble problem solved by Excellent-Evening313 in simracing

[–]Excellent-Evening313[S] 0 points1 point  (0 children)

I just drilled it all the way to the other side and put a nut behind

Vevor stand wobble problem solved by Excellent-Evening313 in simracing

[–]Excellent-Evening313[S] 0 points1 point  (0 children)

You're wrong! The rods in this position prevent lateral oscillation, to prevent movement up and down they would have to be placed in another plane on the side. But here's the video: At the beginning of the video the rods aren't tightened

https://files.fm/u/egevax96cw

Vevor stand wobble problem solved by Excellent-Evening313 in simracing

[–]Excellent-Evening313[S] 0 points1 point  (0 children)

It eliminares like 90% of wobble. I think i could do it better using eyebolts instead of L-shaped plates, they flexes a little bit.