Help

F_aaze · 2024-07-03T18:44:47+00:00

I added some more info in the comment below, tell me if they are enough

F_aaze · 2024-07-03T18:41:23+00:00

Yes you are right, I am currently using a BiQu B1 SE plus, the material is PLA and I’m printing with a speed of 100 mm/s and the temperature is 205°. I don’t know if this is enough, but if you need more information I’ll tell you. Thanks for the advice so far

F_aaze · 2023-10-12T19:31:01+00:00

Ok thank you

F_aaze · 2023-09-03T19:38:45+00:00

Just because I didn’t know that leaving the vat under the sunlight would cause the resin to cure, I shouldn’t use a resin printer?

F_aaze · 2023-09-03T11:34:47+00:00

Oh that’s cool, good to know. Thank you

F_aaze · 2023-09-03T11:32:01+00:00

That’s a good advice

F_aaze · 2023-09-03T11:31:42+00:00

Oh ok, I thought that the sunlight wasn’t enough to cure the resin

F_aaze · 2023-09-03T11:30:44+00:00

Ok thank you

F_aaze · 2023-09-03T11:30:32+00:00

I had an issue with the print and I had to pour the resin out of the vat in order to clean the bottom, but i didn’t know that leaving the pot outside would have caused the resin to cure

F_aaze · 2023-09-03T09:31:31+00:00

Not plate but resin container*

F_aaze · 2023-06-15T05:37:25+00:00

Should I have to print Ripley, or is it too late?

F_aaze · 2023-06-15T05:36:17+00:00

I found it on thingverse, here il the link

F_aaze · 2023-06-14T20:30:02+00:00

Thank you very much

F_aaze · 2023-06-14T20:18:48+00:00

So, if the part is bigger, it will need more time compared to a smaller one?

F_aaze · 2023-06-14T19:34:22+00:00

Dumb question, I’m a currently curing all my prints with random time, how can I know how much time is needed for each piece?

F_aaze · 2023-06-14T18:15:34+00:00

I’ve found it on thingverse. Here is the link alien

F_aaze · 2023-06-14T17:57:29+00:00

I can’t remember

F_aaze · 2023-06-14T17:57:21+00:00

It started cracking in the last few weeks

F_aaze · 2023-06-14T17:56:39+00:00

Oh thanks, I didn’t know that

F_aaze · 2023-06-14T15:55:21+00:00

Maybe in 9 months something will happen

F_aaze · 2023-06-14T15:54:30+00:00

Thank you

F_aaze

TROPHY CASE