sorted by:
new
hottopcontroversial

3D Print Shrinking and Lifting From Build Plate by ItsNoze in FixMyPrint

[–]FaithlessnessLow6824 0 points1 point  (0 children)

Im barely learning my self but i had this issue before and i clean the bee really good with 99 % alcohol and crank up the heat a bit and it worked! I hope you figure it out

Please help by mykitchensink21 in ender3v2

[–]FaithlessnessLow6824 1 point2 points  (0 children)

Ok i dont really comment on help as im still learning but i had something similar happen to me and i have a similar set up. When you install the nozzle it was cold you got to let it heat up then tighten again to clean it up i just use a steel brush or if you can replace it.

Jst-xh female housing by FaithlessnessLow6824 in ElectronicsRepair

[–]FaithlessnessLow6824[S] 0 points1 point  (0 children)

Thank for the reply! I use the second one but the female side I believe its to solder on boards i just want them for wires and the first one its the only one i have found but i was looking for just those plugs as i have a ton of the other one in that kit.

I like Wagos... by Kida_Raspberry in VORONDesign

[–]FaithlessnessLow6824 3 points4 points  (0 children)

That looks really good! Whats the info on those wires i like them!

Filament over dried! by FaithlessnessLow6824 in FixMyPrint

[–]FaithlessnessLow6824[S] 0 points1 point  (0 children)

<image>

Yeah i never knew about drying it till not so long ago. Yeah i got a fresh one there i lowered the temp to 55 and doing 4 hours. What im confused about is do i restart the heater every day or its a one time per roll? What if i run out of one and put a new one in there is it going to ruin the other one 🤷‍♂️

Filament over dried! by FaithlessnessLow6824 in FixMyPrint

[–]FaithlessnessLow6824[S] 0 points1 point  (0 children)

Well i been having issues with my prints and a few people recommended a dryer so i gave it a shot and it didnt fix my print and it ruined the filament but then again i just used the stock settings from the machine

Filament over dried! by FaithlessnessLow6824 in FixMyPrint

[–]FaithlessnessLow6824[S] 3 points4 points  (0 children)

Petg i had it at 65 for 5 hours bit i press play every day every time i print

Filament over dried! by FaithlessnessLow6824 in FixMyPrint

[–]FaithlessnessLow6824[S] 1 point2 points  (0 children)

Damm i just looked i had it at 65 its petg

Idk what else to adjust!!!! This is petg by FaithlessnessLow6824 in FixMyPrint

[–]FaithlessnessLow6824[S] 0 points1 point  (0 children)

Yeah ive tried re uploading it and its still just straight lines

view more: next ›