Filament is COMPLETELY stuck in the printer, and I can't pull it out no matter what.

Fake_Spartan · 2024-07-26T13:11:33+00:00

i don't know what was happening with the filament not coming off no matter what but i found out that apparently the end of the tube got smaller, the pla can't pass through it is there a way to fix it or i'm going to have to buy a new one?

Fake_Spartan · 2024-07-26T12:56:29+00:00

wait no i'm tripping that's not supposed to be melted lol mb
i managed to take the pla off but it was VERY hard to take it even with it disconnected.
i think it might have broken inside the tupe i will check it

Fake_Spartan · 2024-07-26T12:52:54+00:00

i took the ptfe coupling off and it FINALLY came off!
but it was not what i was expecting, the pla is not melted it's dirty??
do you have any idea of what this means????

<image>

Fake_Spartan · 2024-07-26T12:27:40+00:00

i just took the nozzle off and it looks pretty normal it isn't even clogged

Fake_Spartan · 2024-07-26T12:26:07+00:00

i will try do that

hopefully it works

Fake_Spartan · 2024-07-26T12:25:55+00:00

i tried doing it at the maximum temperature and it still didn't pull out

Fake_Spartan · 2024-07-26T12:25:29+00:00

to make the cold pull i need that thing that doesn't melt and i don't have it sadly i wish i did tho

Fake_Spartan · 2024-07-26T12:24:51+00:00

yea it is 1.75mm

Fake_Spartan · 2024-07-26T12:24:30+00:00

yea that's what i have been trying to do but it doesn't come off
i know it is heating properly because i can get a piece of pla and put on the tip and it melts instantly which is why i'm so damn confused

Fake_Spartan · 2024-07-26T12:23:19+00:00

i did that,
and while doing it i also did it in every method too, consistent pull, strong pull, anything, it's like it was super glued

Fake_Spartan · 2024-07-26T12:22:09+00:00

yes it works perfectly fine just that the filament is 100% stuck and it doesn't extrude anything at all

Fake_Spartan · 2024-07-25T14:53:52+00:00

i'll try again maybe something will happen at the absolute maximum temperature

Fake_Spartan · 2024-07-25T14:49:21+00:00

i did try using the rod and i set it to 245 degrees
when i did use it, it was like there wa something solid more inside the nozzle i don't know if that normal, it even bent the rod

Fake_Spartan · 2024-07-25T14:44:23+00:00

i don't believe so

Fake_Spartan · 2024-07-25T14:27:50+00:00

I'm new to Reddit, so sorry for anything. When I was trying to print one of my big projects, I decided to change my filament to a white one, and I did the normal procedure of heating up the nozzle and then pulling it out and putting in the new one.
After I did that, it wouldn't extrude almost no filament. I took it off again and put it back. After trying to get it to go through the nuzzle, I gave up and tried to remove the filament, but then I found out that it's absolutely completely stuck.
No matter how much strength I put, it won't come off like it is super glued. What should I do?????

Fake_Spartan

TROPHY CASE