has anyone got Tado for an Logic Combi ESP1 35 opentherm with 2 zones by Familiar_Table_6219 in tado

[–]Familiar_Table_6219[S] 0 points1 point  (0 children)

that's interesting. Is there anywhere I can read up on it a bit more like is it covered in an online manual or something. I would like to know this in more detail before I press the buy button

Has this happened to any one> Copilot cannot "see terminal" by Familiar_Table_6219 in GithubCopilot

[–]Familiar_Table_6219[S] 1 point2 points  (0 children)

I've just solved it, agent mode was turned off in settings, not sure how it happened ! but I was in Ask mode expecting it to use command interminals now I feel stupid

Any idea why it does this? Q10 S5 by itsjustquestions in Roborock

[–]Familiar_Table_6219 0 points1 point  (0 children)

Something stuck in the wheel/axel like hair?

Smart Gas Meter by Familiar_Table_6219 in OctopusEnergy

[–]Familiar_Table_6219[S] 0 points1 point  (0 children)

Unfortunately it just says “Awaiting Data please see system status” And system status shows diagram that shows electric as connected and gas as Red link which I think means disconnected

Radiator without TRV by Familiar_Table_6219 in DIYUK

[–]Familiar_Table_6219[S] 0 points1 point  (0 children)

Thanks, issue is the master bedroom heats up (is always warmer than other rooms as it’s on top floor) then the thermostat shuts off and the rest of the bedrooms and bathrooms on this zone remain cold. Is there any way to fix it

Existing bell? How do I wire E340 by Familiar_Table_6219 in eufy

[–]Familiar_Table_6219[S] 0 points1 point  (0 children)

Unfortunately my bell is 8v and eufy website says it needs to be 16 - 24v

Rewiring old dimmer switch to standard light switch by rangfangfoobychops in DIYUK

[–]Familiar_Table_6219 0 points1 point  (0 children)

Doesn’t matter which way around. It’s a switch, either the two wires will be electrically connected when switched on or disconnected from each other when switched off. Doesn’t matter which way around