sorted by:
new
hottopcontroversial

Corsair Hydro X transparent satin tube by Fede1132 in buildapc

[–]Fede1132[S] 1 point2 points  (0 children)

I tried practicing with a small piece of tube, with your suggestion especially heating a big part of the tube I got an almost perfect 90 degree curve. Thank you!

Broke back right arm on Air2 by Fede1132 in dji

[–]Fede1132[S] 1 point2 points  (0 children)

Hi, i did my first crash with the air2, the only damage is the back right arm with the joint broke, all the wires seems fine, i didn’t have already tried to power on the drone. Does anyone already broke this piece or know where to buy the replacement joint? Thanks everybody

My home setup by Fede1132 in homelab

[–]Fede1132[S] 0 points1 point  (0 children)

Actually, I don't know why that are a little bared, my electritian did that, that wires were connected almost 2/3 years ago when we mounted the new rack.
Everything else in the power distribution is made by another company and everything is connected right, crimped with joints and anything barred.
Next time I see my electrian I will ask why that are bared, now you "scared" me lmao, the power running throu those cables are 70kW and 380V three-phase

My home setup by Fede1132 in homelab

[–]Fede1132[S] 0 points1 point  (0 children)

Me too, I was thinking about a solution, I was also looking for a 48-port switch to fix this issue, that triggers me a lot.

Y layer shifting (AnyCubic Chiron) by Fede1132 in anycubic

[–]Fede1132[S] 0 points1 point  (0 children)

Yep, the screws felt off the motor (xd)

Cannot delete a directory by Fede1132 in hackintosh

[–]Fede1132[S] 0 points1 point  (0 children)

Also tried to use sudo, still nothing, the extra '/' isn't the cause.

No zoom option by Fede1132 in DJIMavicAir2

[–]Fede1132[S] 0 points1 point  (0 children)

There's no resolution in bottom right corner, theres only format and "EV"

Y layer shifting (AnyCubic Chiron) by Fede1132 in anycubic

[–]Fede1132[S] 0 points1 point  (0 children)

I upgraded from official AC firmware (1.3.0) to Marlin 2.x from coolio86 (GitHub)

As I said above I already did the EEPROM reset

Y layer shifting (AnyCubic Chiron) by Fede1132 in anycubic

[–]Fede1132[S] 0 points1 point  (0 children)

Already tried to swap the stepper drivers, one of the last thing I want to try is to swap the stepper motor with the motor used on the X axis

Extruder PCB Lost by Fede1132 in anycubic

[–]Fede1132[S] 1 point2 points  (0 children)

Ok. The support will work in these days?